Timberk SWH SE1 30 VO - Инструкция по эксплуатации - Страница 6

www.timberk.com • electrical storage water heater

6

6. DELIVERY SET

7. WATER HEATER INSTALLATION

1. Electric storage water heater – 1 pc.
2. Pressure safety valve – 1 pc.
3. Mounting strip for hanging/mounting of water heater – 1 pcs.
4. Instruction manual – 1 pc.
5. Guarantee card – 1 pc.
6. Packing – 1 pc.

Location

1. The water heater of 

SWH SE1 VO series

 can be installed over a 

washbasin, a kitchen sink or in any other place where it will not hinder you. 

Please, note, that pipes must be placed on the bottom part of water heater. 
2. The water heater of 

SWH SE1 VU series

 can be installed under a 

washbasin, a kitchen sink or in any other place where it will not hinder you. 

Please, note, that pipes must be placed on the top part of water heater. 
3. Electric water heater should be mounted on a firm wall.
4. The wall where the electric water heater is to be mounted must withstand 

at least the double weight of the water heater fully filled with water. There 

must be no cracks and other damages on the wall. Otherwise, it is necessary 

to take measures to strengthen the mounting or install the water heater on 

a special support.
5. If a bathroom is too small the water heater can be installed in any other 

place unexposed to direct sunlight and beyond the reach of moisture. 

However, to reduce heat losses in pipelines the location where the water 

heater is to be installed must be as close to the place of hot water use as 

possible.

Water heater mounting

1. After you have chosen a proper place to install the water heater 

determine points for holes for fixing of mounting strip, putting the strip to a 

wall. Drill holes of corresponding depth in the wall using a drill dimensionally 

fit for anchor bolts delivered together with the water heater. Next, fix the 

mounting strip on a wall with help of screws. After that you should mount 

water heater on a mounting strip (fig. 7).

Connection to the water main

1. The water heater must be connected to the water main with minimum 

pressure of 0.1 MPa and maximum pressure of 0.7 MPa.

NOTE:

To install the water heater, please, use accessories 

provided by the manufacturer. Electric water heater 

must not be mounted onto the wall before you make 

sure that the mounting strip is installed firmly and 

securely. Otherwise, the electric water heater may fall 

down from the wall that may cause its damage and 

even more serious accidents involving harm to health 

and personal injuries.

NOTE:

In the places accessible for water the AC electrical 

main socket must be installed on a height of at least 

1.8 m from the ground.

2. Fasten an AC main socket to the wall. Requirements to the socket are 

as follows: ~220V / 10А, single-phase, three wires. It is recommended to 

place the socket from the right side higher of the water heater.

Fig. 7