Timberk SWH RE9 80 V - Инструкция по эксплуатации - Страница 10

www.timberk.com • electrical storage water heater

10

IMPORTANT! 

Water can start to drip from the opening of safety  valve  

then heating process is going. It’s impossible to avoid 

leakage of water and you can’t  prevent this! Locking 

of valve may cause rupture of the inner tank in case  

of  failure.

IMPORTANT! 

“

♥

” position on the control panel corresponds to the 

optimum water heating temperature of 58 +/-2°C, at 

which:
1. The user is less likely to get burned in case when the 

outlet water temperature is incorrectly adjusted.
2. A sufficient amount of hot water is obtained after 

mixing with cold water, at a lesser power energy 

consumption.
3. Less scale is generated on the heating element and 

internal surfaces of the water heater.

3. Turn the thermostate handle (7) (fig. 4) clockwise and set the desirable 

temperature. The temperature can be set from +35°C (±5°С) (MIN» 

position of the thermostat knob) up to 75°C (±5°С) (rightmost position of 

the thermostat knob). To reduce the water temperature turn the handle 

anticlockwise.
4. Water  temperature keeps  up  by  the  thermostate automatically. When 

water temperature reach the set level, Heating is automatically switched off. 

At that, the indicator lamp in the lower part of the appliance extinguishes. 

When the temperature be lower then set, the heating will automaticlly start 

again and the indicator lamp lights up.
5. To turn off the waterheater, turn the handle to the closest left position 

«Off» and unplug the power cord or disconnect the appliance from the power 

supply.

IMPORTANT! 

The outlet must be designed for rated current not less 

than 10A, electric cable with copper core must have 

cross section not less than 3x1.5 mm2 (for copper).