Timberk SWH ME1 10 VU - Инструкция по эксплуатации - Страница 9

www.timberk.com • electrical storage water heater

9

Termostat handale

SWH ME1 series

1. At first, open one of the discharge valves on the outlet of the water 

heater, then open the inlet valve. The electric water heater will start filling 

with water. When water flows from the outlet valve freely, it means the water 

heater is fully filled with water and you can close the discharge tap.
Warning: During normal operation the inlet valve must be set “open”.
2. Plug the power cord into the outlet, an indicator light will light up.

3. The appliance can automatically control water temperature. When 

water temperature in the water heater reaches the temperature, set by the 

user, the heating is automatically switched off, and water temperature will 

be maintained due to the heat insulation layer; when water temperature 

drops to a certain level, heating is automatically switched off, in such a 

way continuous hot water supply is provided. When the water heater 

automatically switches off, the indicator light goes out.

9. WATER HEATER OPERATION 

IMPORTANT! 

Power outlet must be designed for rated current not 

less than 10A, copper stranded power cord not less 

than 3 x 1.5 mm

2

 in cross section (for copper).

4. If you will turn the thermostat handle clockwise, you’ll increase the  

temperature of heating. Maximum temperature inside inner tank is +75°C 

approx. If you want to reduce the temperature of water, please, turn the 

handle anticlockwise. 
5. If you choose position of thermostat handle like “optimum” or            , it 

means you choose the most comfortable water temperature +58°C (±2°C).
6. The appliance can automatically control water temperature. When 

water temperature in the water heater reaches the temperature, set by the 

user, the heating is automatically switched off, and water temperature will 

be maintained due to the heat insulation layer; when water temperature 

drops to a certain level, heating is automatically switched off, in such a 

way continuous hot water supply is provided. When the water heater 

automatically switches off, the indicator light goes out.
7. If you will turn the thermostat handle clockwise, you’ll increase the  

temperature of heating. Maximum temperature inside inner tank is +75°C 

approx. If you want to reduce the temperature of water, please, turn the 

handle anticlockwise. 
8. If you choose position of thermostat handle like “optimum” or           , it 

means you choose the most comfortable water temperature +58°C (±2°C).

Fig. 7

GFCI (Ground Fault Circuit Interrupter)

1. Connect the cable to the mains, indicator (1) will light up.
2. Press button (2) for testing, voltage will be cut off, indicator (1) will light 

down and restart button (3) will go upwards.
3. Press button (3) to restart the appliance, voltage will be restored and 

indicator (1) will light up.