Водонагреватели Polaris VEGA TS 5.5 кВт / - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
14
Incorrect! Danger!
Do not fit a tap
at the water outlet!
Correct installation
Danger! Incorrect installation!
Temperature
control
Filter
Rings
Water outlet
At the water outlet u se only
accessories su pplied with the device!
Filter
Water inlet
Rings
Water outlet
Temperature
control
Scheme 1. Electrical wire-lead termination
3.
The temperature of the output water is regulated by
“temperature control” together with the combination of
“rings” in the shower head or in “tap-goose”. On the
diagram it is shown the influence of the set temperature on
the water flow.
Temperature control is used to regulate the water temperature.
The higher is the temperature of output water, the smaller is the water flow and vice versa.
The combination of rings is used to regulate the water flow. During winter period only small open
ring with inlays should be used (very hot water). Small and medium rings with inlays should be
used in autumn and spring (medium water heating level). Small, medium, big open rings with inlays
should be used in summer (warm water).
In case the water flow is poor or the water is spraying in wrong direction, the rings should be
cleaned.
In case the quantity of input water is decreasing, it is necessary to clean the filter which is installed
at the water inlet.
Special recommendations
Scheme 2. Water heater setting
•
The cold water input is marked by the blue color
•
The hot water output is marked by the red color
1.
The cover should be removed from the base. First unscrew the four screws on the exterior
circumference of the heater and then remove the cover.
2.
Insert (without connecting) the electrical cable into the heater through one of the channels
intended for this purpose, after opening the thin panel in the base beyond the cable.
T
em
p
e
ra
tu
re
Water volume liter/min
Water inlet
