PHILIPS AWH1617/51(80YB) - Инструкция по эксплуатации - Страница 13

11

Electrical connection

1   Do not mount additional devices, such as 

a  shut-off  valve,  between  the  safety  valve 

and the inlet pipe 

2   If the water at the installation site contains 

a large amount of calcium, manganese or 

iron salts, then it is necessary to install an 

appropriate  filter  in  the  supply  system  to 

reduce the amount of scale in the tank and 

on the heating element 

3    Before connecting the storage water heater, 

make sure that the water heater is properly 

grounded  Proper grounding is important 

to minimize electric shock and fire hazards. 

The power cord is equipped with a plug 

with a grounding contact  The device must 

be used with a properly grounded power 

outlet  If the outlet you plan to use is not 

properly grounded or protected by a time 

delay fuse or circuit breaker, contact a 

qualified  electrician  to  install  the  correct 

outlet 

4   

To ensure reliable operation and safe 

operation of the water heater, before using 

it for the first time, check that it is correctly 

connected to an AC 220 V electrical 

network  The connected water heater 

must be securely connected to the ground 

loop of your electrical network  Using the 

water  heater  without  grounding  is  life-

threatening 

1   Before connecting, make sure that the 

power supply at the connection point 

matches the parameters indicated on the 

identification  plate  with  the  technical 

data of the device  The water heater is 

designed  to  be  connected  to  a  single-

phase 220–240 V electrical network  

When installing the water heater, the 

current electrical safety regulations must 

be observed 

2   The electrical outlet and plug must be 

kept dry at all times to prevent electrical 

leakage  Regularly check that the electrical 

plug is firmly connected to the outlet. The 

electrical socket must be designed for a 

rated current of at least 10 A, an electrical 

cable with a core cross section of at least 

3 × 1 5 mm2 (for copper)  Carry out the 

check in the following order: insert the 

electric plug into the socket, after half 

an  hour  of  operation,  turn  off  the  water 

heater and remove the plug from the 

socket, check with your hand if the plug 

has warmed up  If the plug has become 

hotter than 50°C, replace the outlet with a 

different one to avoid damage, accidents, 

or fire due to poor electrical contact. This 

should be done by a specialist 

Attention!