ATLANTIC Vertigo Basic 100 - Инструкция по эксплуатации - Страница 11

11

EN

GENERAL WARNINGS

10. Mandatory installation of a safety device in a frost-free location (or any 

other new device which limits the tank pressure) to 0.7 or 0.9 MPa (7 or 

9 bar) according to the nominal pressure, with a size of 1/2» in the input 

of the water heater, respecting the local regulations

11. Operate regularly the discharge of safety device to prevent scaling and 

check that it is not blocked.

12. Hydraulic accessories should not be located between the safety valve 

and the cold-water inlet. A pressure reducer (not supplied) is required 

when the water supply pressure exceeds 0,5 MPa (5 bar) and will be 

fi tted on the main supply.

13. Connect the safety device to an unpressurised outlet pipe in a frost-free 

location, with a continuous slope to evacuate water during heating up 

or draining the water heater.

14. The pipes used must support 1 MPa (10 bar) and 100 ° C.

15. To drain the device: Switch off the power and the supply of cold water, 

open the hot water faucets and manipulate the safety valve.

16. The products described in this manual are subject to changes at any 

time to be in accordance with technology and standards. The devices 

comply with Electromagnetic Directive 2014/30/UE, Low Voltage Direc-

tive 2014/35/UE, Directive 2011/65/UE for RoHS and Regulation 2013/814/

UE supplementing Directive 2009/125/EC for ecodesign.

17. Do not dispose your water heater in the garbage, but hand it to 

a place assigned for this purpose (collection point) where it can be 

recycled.

18. This product is intended for use at a maximum altitude of 3000m.

19. Always connect the earth conductor of the cable to the earth ground 

or connect the earth conductor to the appropriate terminal identifi ed 

by the symbol

 .

20. The instruction book of this product is available by contacting the after-

sales service.