Ariston SUPERLUX FLAT PW 100 V 3700469 - Инструкция по эксплуатации - Страница 33

EN

33

Safety valve 

Regularly check that the overpressure device is not jammed or damaged; if it is, remove any scale or 

replace it.

If the device has a lever or knob, operate it to: 

- drain the appliance, if necessary 

- check its operation from time to time.

USER INSTRUCTIONS

CAUTION Observe all general warnings and safety standards listed at the begin-

ning of this text in full; all such instructions are obligatory.  

Advice for user 

- Avoid positioning any objects and/or appliances that could be damaged by water leaks beneath the water 

heater. 

- Should you not use any water for an extended period of time, you should: 

➣

 disconnect the appliance from the electrical supply by switching the external switch to “OFF”; 

➣

 turn off the plumbing circuit taps. 

- Hot water at above 50°C flowing out of the taps at the point of use could cause serious scalds or even death 

from burns. Children, the disabled and the elderly are more exposed to the risk of burns. It is strictly forbidden 

for the user to perform any routine or extraordinary maintenance.

To clean the external parts use a damp cloth soaked in soap and water.

Adjusting the temperature and activating the functions

The product is switched off by default. When the appliance is swithced on, slight noise may occur during the 

heating phase due to the water being heated.

Standard Mode (Single Power)

Switch the appliance on by rotating counterclockwise the knob (Fig. 8, Ref. 

A

). Set the desired temperature 

by rotating the knob between 40, 60 or 80°C on the single power side (left side, Ref. 

A

). During the heating 

phase, the LEDs (Ref. 

1-3

) related to the temperature reached by the water remain on; the subsequent ones, 

until the temperature is set, flash progressively. If the temperature drops, for example due to water being 

drawn, the heating is automatically reactivated and the LEDs between the last one on (steady) and that 

related to the set temperature start to flash progressively again.

• Double Power Mode

The product operates normally at base power. In “ Double Power Mode “ the appliance operates at maximum 

power to speed up the water heating. Switch the appliance on by rotating clockwise the knob (Fig. 8, Ref. 

A

). 

During the heating phase, the LEDs (Ref. 1-3) related to the temperature reached by the water remain on; 

the subsequent ones, until the temperature is set, ash progressively. Set the desired temperature by rotating 

the knob between 40, 60 or 80°C on the Double Power side (right side, Ref. 

A

).

Reset/Diagnostics

When a malfunction described above occurs, the appliance will enter its “fault status” and all LEDs on the 

control panel will flash simultaneously.

Error reset: reset the appliance by switching it off and by rotating the knob (Ref. 

A

). If the cause of the 

malfunction disappears immediately when reset, the appliance resumes its regular operation. On the 

contrary, if the error code continues to appear on the display: contact the Technical Service Centre.

Additional Functions

The function is enabled by default and cannot be disabled.

Anti-freeze function

The anti-freeze function is the appliances automatic protection to avoid damages caused by very low 

temperatures below 5 °C, in the event in which the product is turned off during winter. It is recommended that 

the product remains plugged in to the mains power, even if it is inactive for a long time.

For all models, once the temperature rises to a safer level such as to avoid damage from ice and frost, the 

water heating is switched off again.