Ardesto EWH-15OMWMI - Инструкция по эксплуатации - Страница 11

EN

11

GENERAL SAFETY INSTRUCTIONS

1.  

Read the instructions and warning in this manual carefully, 

they contain important information regarding safe installa-

tion, use and maintenance. 

This manual is an integral part of the product. Hand it on to 

the next user/owner in case of change of property.

2.   The manufacturer shall not liable for any injury to people, ani-

mals or damage to property caused by improper, incorrect or 

unreasonable use or failure to follow the instructions reported in 

this publication.

3.   Installation and maintenance must be performed by profession-

ally qualified personnel as specified in the relative paragraphs. 

Only use original spare parts.

Failure to observe the above in-

structions can compromise the safety of the appliance and 

re-

lieves

 the manufacturer of any liability for the consequences.

4.   DO NOT leave the packaging materials (staples, plastic bags, 

expanded polystyrene, etc.) within the reach of children - they 

can cause serious injury.

5.   The appliance may not be used by persons under 8 years of 

age, with reduced physical, sensory or mental capacity, or lack-

ing the requisite experience and familiarity, unless under super-

vision or following instruction in the safe use of the appliance 

and the hazards attendant on such use. DO NOT permit children 

to play with the appliance. User cleaning and maintenance may 

not be done by unsupervised children.

6.  

DO NOT

 touch the appliance when barefoot or if any part of 

your body is wet.

7.  Before using the device and after routine or extraordinary main-

tenance, we recommend filling the appliance's tank with water 

and draining it completely to remove any residual impurities.

8.  If the appliance is equipped with a power cord, the latter may only 

be replaced by an authorised service centre or professional tech-

nician.

9.   It is mandatory to screw on the water inlet pipe of the unit a 

safety valve in accordance with national regulations. In coun-

tries which have enacted EN 1487, the safety group must be 

calibrated to a maximum pressure of 1487 MPa (0,7 bar) and 

include at least a cock, check valve and control, safety valve and 

hydraulic load cutout.

10. Do not tamper with the overpressure safety device (valve or