Варочная панель MBS PG-911 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Models with hidden ignition system under the switch
These models are identified with a symbol near symbol (Largest flame for maximum
gas distribution). In order to ignite any burner (compartment), it is necessary to switch it
to the large flame position while pushing it down at the same time. When the burner is
ignited, the required flame density can be adjusted by turning the switch.
Burners with security valve
Some models are equipped with security valves which are automatically switched off in
case of gas cutouts due to any reason. In order to re-ignite the burner, turn the switch to
position and repeat the ignition procedure as described in the following paragraph.
Usage of the burners
Apply the following procedure according to the system,
·
For system with a hidden ignition system under the switch, turn the switch to
"maximum gas distribution position". Push the switch down and hold it there for 4-5
seconds. When the burner is ignited, turn the switch in order to adjust for required gas
density.
Warning:
·
Do not use ignition equipment longer than 15 seconds. If the burner is not
ignited during this period or if the gas is cutout for any reason, then perform the
ignition procedure after 1 minute.
·
For models with an ignition button, turn the switch to "maximum gas distribution"
position and push down the gas and ignition buttons at the same time and wait for 4 5
seconds. When the ignition is performed, adjust the required gas density by turning the
gas switches.
Usage of grills
Stewpot placement grills are designed for secure and easy usage of the equipment.
Before using the equipment, make sure that the grill is placed correctly. In addition, verify
that plastic protective stands are present and they are placed properly.
Teapot or small stewpot grill
This part is placed on the auxiliary compartment (the smallest compartment). When a
stewpot with a small diameter or a teapot is placed on the cooker, it is used to maintain
balance (Figure 19).
Special WOK blaze grill (optional)
This part is placed on the WOK blaze compartment in order to protect the burner being
seriously damaged when a WOK pan (pan with a concave base) is placed on the cooker.
Always
use the WOK blaze compartment together with this special piece. When
skewpot with flat base is used, never use this part.
Models with hidden ignition system under the switch
Burners with security valve
Usage of the burners
Warning:
Do not use ignition equipment longer than 15 seconds. If the burner is not
ignited during this period or if the gas is cutout for any reason, then perform the
ignition procedure after 1 minute.
Usage of grills
Teapot or small stewpot grill
Special WOK blaze grill (optional)
Alwaysuse the WOK blaze compartment together with this special piece. When
skewpot with flat base is used, never use this part.
These models are identified with a symbol near symbol (Largest flame for maximum
gas distribution). In order to ignite any burner (compartment), it is necessary to switch it
to the large flame position while pushing it down at the same time. When the burner is
ignited, the required flame density can be adjusted by turning the switch.
Some models are equipped with security valves which are automatically switched off in
case of gas cutouts due to any reason. In order to re-ignite the burner, turn the switch to
position and repeat the ignition procedure as described in the following paragraph.
Apply the following procedure according to the system,
For system with a hidden ignition system under the switch, turn the switch to
"maximum gas distribution position". Push the switch down and hold it there for 4-5
seconds. When the burner is ignited, turn the switch in order to adjust for required gas
density.
For models with an ignition button, turn the switch to "maximum gas distribution"
position and push down the gas and ignition buttons at the same time and wait for 4 5
seconds. When the ignition is performed, adjust the required gas density by turning the
gas switches.
Stewpot placement grills are designed for secure and easy usage of the equipment.
Before using the equipment, make sure that the grill is placed correctly. In addition, verify
that plastic protective stands are present and they are placed properly.
This part is placed on the auxiliary compartment (the smallest compartment). When a
stewpot with a small diameter or a teapot is placed on the cooker, it is used to maintain
balance (Figure 19).
This part is placed on the WOK blaze compartment in order to protect the burner being
seriously damaged when a WOK pan (pan with a concave base) is placed on the cooker.
·
·
·
4
4
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)
