De Dietrich DPI7540B - Инструкция по эксплуатации - Страница 36

•

2

USE

29

or

-

(2.13.2)

.

Set the quantity of water required (from
0.5 to 6 litres). 
Confirm by pressing the «Boil» symbol or
wait a few seconds for automatic confir-
mation.
Cooking starts.
A beep sounds when the water is boiling
and the "Boil" symbol scrolls through the
display 

(2.13.3)

.

You can then add the pasta and confirm
by pressing the «Boil» key.
By default, the display shows the power
and a cooking time of 8 minutes.
You can still adjust the power and the
cooking time suggested.
A beep sounds out when cooking is
finished.

NOTE: 

It is important that water is at

ambient temperature at the start of
cooking or the final result will be
distorted.
Do not use a cast iron pan with this
function.
You can also use this function to cook
any food that needs to be cooked in
boiling water.

Advice on how to save energy

Cooking with the correctly sized lid

saves energy. If you use a glass lid, you
can control your cooking perfectly. 

2.14 SAFETY DEVICES AND
RECOMMENDATIONS
Residual heat 

After intensive use, the cooking area you
have just used will remain hot for several
minutes.
An "H" is displayed during this time

(2.14.1)

.

So, avoid touching the zones concerned.

g

Temperature limiter

Each cooking area is fitted with a safety
sensor that continuously monitors the
temperature of the bottom of the pan. In
the event that an empty pan is left on a
zone that is switched on, the sensor
automatically adapts the power
delivered by the hob and limits the risk of
damaging the cookware or the hob.

Spillage protection

The hob may be switched off in the
following three cases:
- A spillage in the touchkey area 

(2.14.2)

.
- Damp cloth placed over the touchkeys. 
- A metal object placed on the touchkeys

(2.14.3) 

.

Remove the object or clean and dry the
touchkeys and then continue cooking.
In these cases, the symbol 

is

displayed accompanied by an audible
signal.

«Auto-Stop» system

If you forget to switch off a pan, your
hotplate has an “Auto-Stop” safety
function that automatically switches off
the forgotten cooking zone after a preset
time (between 1 and 10 hours based on
the power level setting).
If the safety system is triggered, the
cooking zone is shown as cut off with
"AS" displayed on the control panel and
a beep sounds for about 2 minutes. To
stop it, simply press any of the control
buttons. 

Sounds similar to the ticking of a
clock may be heard.

These sounds occur when the hob is in
operation and disappear or decrease
according to the heating configuration.