KRAFT Technology TCH-HV6910BGE - Инструкция по эксплуатации - Страница 23

23

ВСТРАИВАЕМАЯ ГАЗОВАЯ ВАРОЧНАЯ ПАНЕЛЬ

GAS BUILT-IN HOB

ИНСТРУКЦИЯ ПО ЭКСПЛУАТАЦИИ • USER GUIDE

 IMPORTANT: The appliance must be installed by a skilled and qualified installer who is 

familiar with the installation rules in force.

•  Installation must be carried out by an authorized technician according to the guidelines.
•  Improper  installation,  maintenance  and  operation  can  cause  significant  property  damage 

or personal injury. 

•  The appliance can only be installed and operate in permanently ventilated rooms according 

to the local regulations in force.

•  The ventilation openings must have a effective cross-section of at least 100 cm

2

 and must 

be protected against accidental blocking (protection with metal grills or grids).

•  The furniture walls in which the appliance is installed in must be heat resistant. Wall panels 

must  be  resistant  to  100  °C  especially  if  the  sidewalls  are  made  of  wallboard.  Plastic  or 

adhesive panels that are not resistant to this heat may deform and sustain damage.

•  Make sure the appliance is securely fixed in your furniture.
•  It is not advised to install the device near refrigerators or freezers, otherwise performance of 

said devices would be affected from the heat radiated.

•  Direct contact with electrical parts of the appliance should be avoid.
•  Our company cannot be held responsible for the damages to people, animals or properties 

due to improper installation.

The dimensions of the embedding holes are shown on the picture, with the minimum distance 

to be observed between the embedding hole and the side and rear walls.

- no gas supply

- maximum gas supply

- minimum gas supply

ContRoL PAneL 

InstALLAtIon

The  hob  control  area  houses  the  devices  and  knobs  for  operation  of  the  gas  burners 

(2 or 4 (pcs)). 

The  burner  regulation  knobs  can  be  turned  anticlockwise  from  the  closing  position   

to  the  widest  open  position    and vice versa in the opposite direction      (put  the  needle  to  the 

position required)