Kuppersberg FV9TGRZ - Инструкция по эксплуатации - Страница 13

13

english

Technical passporT

gas hob

7.2. BAsIC settInGs 

7.2.1. FoR GAs BURneRs 

Operation of the burners and power levels 
Turn the control switch left-wise 

until reaching to maximum level. When 
you press the control switch all burning 
igniters  will  have  flame  to  burn.  Release 
the switch in few seconds after burning 
of the burner, and bring the control switch 
to the desired flame position between the 
maximum and minimum levels.

Closing the burners 

Turn the control switch right-wise to 

close the hob. 

Flame Failure Device (FFD) 

All burners on your hob are equipped 

with Flame Failure Device system against 
flame extinguishing risk (water flow, wind 
etc.) When the flame was gone while the 
burner switch is open such system will 
prevent cutting of the gas supplied to the 
burner. If the burning of the burner will 
be cut due to safety, repeat the burning 
operation by switching the burner switch 
to off position.

Figure 8.

Using Right Burner 

Â

 The pan diameter and the 

burner power should match in order to 
efficiently  use  it.  The  diameters  proper 
for each burner are given in the table. 

Â

 Select the proper pan diameter 

and  volume  in  order  to  define  the 
proper burner.

If the flame is gone when you release 

the switch You should repeat the above 
process. But this time press the switch 
and hold for about 10 seconds. 

WARnInG: 

Do not use burning 

system more than 15 seconds. If the 
burner will not be burned within such 

time or if the flame will be cut for any 

reason whatsoever, repeat burning 
process after waiting for 1 minute.