Kuppersberg FQ663 W - Инструкция по эксплуатации - Страница 7

7

English

TEchnical passporT

gas hob

Â

Remember that the earth wire 

must not be interrupted by the circuit-

breaker.

Â

Alternatively, the electrical 

connection may also be protected by 

a high sensitivity differential circuit 

breaker.

Â

You  are  strongly  advised  to  fi x 

the relative yellow-green earth wire to 

an effi cient earthing system.

6.4. GAS CONNECTION 

These instructions are prepared for 

specialist personnel having 

required 

competence, the installation of the 
equipment  should be suitable as per 
the applicable standards. 

All gas related works should be 

conducted when the electric connection 
was cut. 

The value plate on the hob indicates 

the gas type intended to be used for use 
with the hob. Connection to the main 
gas course or gas type shall be realized 
after controlling the adjustment as 
per the gas type. Connection to the 
main gas source or gas cylinder shall 
be conducted after checking the 
adjustment according to the proper 
gas type. If it is set properly look at the 
following paragraphs: 

Note that the LPG hoods should 

have standarts stamp and 300 mmSS 

(30mbar) of outlet pressure. 

Natural gas pressure is 200 mmSS 

(20mbar). Please consult the authorized 

service for conversion to natural gas or 

LPG. 

Use only piping, gaskets or stamp as 

per the applicable national standards. 

In some countries where conic 

connections are obligatory, conic 

connection is provided. In such a case 

the conic connection part should be 

connected to the unit.

If the unit will be connected to a 

fl exible  hose,  the  length  of  the  hose 

shall not exceed 120 cm. 

Before starting works related to gas 

installation, please cut the gas supply. 

Make the connection so that 

no pressure will be applied on the 

connection records and piping. Make 

sure that the pipe will not cause any 

clogging or contact with the sharp 

corners. 

Note that the gas hose will not be 

laid through hot areas. 

NOTE: Replace the gas hose of your 

hob  at  4  to  5  years  even  if  it  will  be 

undamaged. 

NOTE:  Check  whether  any  gas 

leakage after the connection with soap 

and water. Do not ever use fl ame. 

Make sure that no additional weight 

to be applied on the gas hose. 

And apply the following order for 

installation:

1. In the order; male adaptor 

cylindrical, gasket, female gas adaptor,