Electrolux EHL 7640 FOK - Инструкция по эксплуатации - Страница 14

7.1 

What to do if...

Problem

Possible cause

Remedy

You cannot activate or op-

erate the hob.

The hob is not connected

to an electrical supply or it

is connected incorrectly.

Check if the hob is correctly

connected to the electrical

supply. Refer to the con-

nection diagram.

The fuse is released.

Make sure that the fuse is

the cause of the malfunc-

tion. If the fuse releases

again and again, contact a

qualified electrician.

Activate the hob again and

set the heat setting in less

than 10 seconds.

You touched 2 or more

sensor fields at the same

time.

Touch only one sensor field.

STOP+GO function oper-

ates.

Refer to "Daily use" chapter.

There is water or fat stains

on the control panel.

Clean the control panel.

An acoustic signal sounds

and the hob deactivates.

An acoustic signal sounds

when the hob is deactiva-

ted.

You put something on one

or more sensor fields.

Remove the object from the

sensor fields.

The hob deactivates.

You put something on the
sensor field  .

Remove the object from the

sensor field.

Residual heat indicator

does not come on.

 The zone is not hot be-

cause it operated only for a

short time.

If the zone operated suffi-

ciently long to be hot,

speak to an Authorised

Service Centre.

Automatic Heat Up function

does not operate.

The zone is hot.

Let the zone become suffi-

ciently cool.

The highest heat setting is

set.

The highest heat setting has

the same power as the

function.

The heat setting changes

between two levels.

Power management func-

tion operates.

Refer to "Daily use" chapter.

The sensor fields become

hot.

The cookware is too large

or you put it too near to the

controls.

Put large cookware on the

rear zones if possible.

www.electrolux.com

14