DeLonghi Pind 30 - Инструкция по эксплуатации - Страница 21

21

IMPORTANT:  Installation  must  be  carried  out  according  to  the  manufacturer’s 
instructions.  Incorrect  installation  may  cause  harm  and  damage  to  people,  ani-
mals or property, for which the manufacturer accepts no responsibility.

Before  carrying  out  any  work  on  the  electrical  section  of  the  appliance,  it  must 
be disconnected from the mains.

Connection to a good earth wiring system is absolutely essential.
The manufacturer accepts no responsibility for any inconvenience caused by fail-
ure to comply with this rule.

ELECTRICAL CONNECTION

5

Replacing the power cord must be done by a qualified electrician in
accordance with the instructions supplied by the manufacturer and in
compliance with established electrical regulations.

A suitable isolating switch providing full disconnection from the mains power supply 
(under overvoltage category III conditions) shall be incorporated in the permanent 
wiring, mounted and positioned to comply with the local wiring rules and regulations. 
The isolating switch must be of an approved type and provide a 3 mm air gap contact 
separation in all poles (or in all active [phase] conductors if the local wiring rules 
allow for this variation of the requirements). 

ELECTRICAL REQUIREMENTS

•  Connection  to  the  electric  power  supply  must  be  carried  out  by  a  qualified  technician

and following the appropriate safety regulations.

• The appliance must be connected to the mains checking that the voltage corresponds

to  the  value  given  in  the  rating  plate  and  that  the  electrical  cable  sections  can  with-
stand the load specified on the plate. 

•  If  the  hob  is  supplied  without  plug,  fit  a  standard  plug  which  is  suitable  for  the  power

absorbed by the appliance and in conformity with the local rules in force.

•  The  plug  must  be  put  into  a  socket  connected  to  the  earth  system  in  compliance  with

safety rules.

• 

• The power supply cable must not touch the hot parts and must be positioned so that it

does not exceed 50°C above ambient.  

•  Once  the  appliance  has  been  installed,  the  power  switch  or  power  plug  must  always

be in a accessible position.

N.B. For connections to the mains power supply, never use adaptors, reductions or
multiple power points as these may overheat and catch fire.

In the event that installation should require modifications to the mains supply wiring sys-
tem, it is recommended that a qualified technician be called to carry out substitution.
The technician will also have to verify that the cross-section of the electric cables on the
power point match the appliance’s power rating.

If the hob surface is cracked disconnect the appliance from the mains and contact
the After-Sales Service.