Варочная панель DeLonghi Pind 30 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
11
BOOSTER FUNCTION REAR COOKING
ZONE ONLY
This function allows the cooking zone to
operate at the
Booster
maximum power
(above the nominal power) for maximum
10 minutes; it could be used, for exam-
ple, to rapidly heat up large amount of
water.
This function is available for the rear
cooking zone only.
T o a c t i v a t e t h e
Booster
f u n c t i o n , t h e
touch control must be switched ON (see
section “
How to Turn the Touch Control
ON and OFF
”).
With the zone at any power level (
0
...
9
),
just touch the key
until the rear zone
display shows “
P
”.
At the end of the
Booster
program (10
minutes) the rear zone is automatically
set to the power level “
9
”.
With the zone at the
Booster
level:
– if touching again the key
- a beep
sounds, the heat up program is can-
celled and the power level set to “
9
”;
– if touching the key
- an error beep
sounds but none change is performed;
– if t o u c h i n g t h e k e y
- a b e e p
sounds, the heat up program is can-
celled and the power level set to “
9
”.
INDUCTION HEATERS POWER
MANAGEMENT
The maximum power of the cooktop is
limited to 3600 W.
This means that the electronic interface
automatically manages the power levels
of the heaters in order to not exceed the
maximum power limit (see also table on
the previous page).
– Both the zones can be used, at the
same time, from power levels “
1
” to
“
9
”;
– With the front zone set to power level
“
7
”, “
8
” or “
9
”, if setting the
Booster
program on the rear zone the power
level of the front zone is automatically
reduced to “
6
".
– With the
Booster
program set on the rear
zone, if setting the power level “
7
”, “
8
”
or “
9
” on the front zone the power level
of the rear zone is automatically reduced
to “
9
”.
