Candy CH 641 TC - Инструкция по эксплуатации - Страница 11

9. PROBLEM SOLVING

The cooking zones do not simmer or only fry gently

Only use flat-bottomed pans. If light is visible between the pan 

and the hob, the zone is not transmitting heat correctly.

The pan bottom should fully cover the diameter of the selected 

zone.

The cooking is too slow

Unsuitable pans are being used. Only use flatbottomed

utensils, that are heavy and have a diameter at least the same 

as the cooking zone.

Small scratches or abrasions on the hob's glass surface

Incorrect cleaning or rough-bottomed pans are used; particles 

like grains of sand or salt get between the hob and the bottom 

of the pan. Refer to the "CLEANING" section; make sure that 

pan bottoms are clean before use and only use smooth   

  bottomed pans. Scratches can be lessened only the cleaning is 
 done 

correctly.

Metal marks

Do not slide aluminium pans on the hob. Refer to the cleaning 

recommendations.

You use the correct materials, but the stains persist.

Use a razor blade and follow the "CLEANING" section.

Dark stains

Use a razor blade and follow the "CLEANING" section.

Light surfaces on the hob

Marks from an aluminium or copper pan, but also mineral, water 

or food deposits; they can be removed using the cream cleaner.

Caramelisation or melted plastic on the hob.

Refer to the "CLEANING" section.

The hob does not operate or certain zones don't work

The shunts are not positioned correctly on the terminal board. 

Have a check made that the connection is done he control panel 

  is locked. Unlock the hob.

The hob does not cut off.

The control panel is locked. Unlock the hob.

The hob stops automatically

A spill covers at least two buttons for more than 10 seconds; the 

hob switches to safety, and an audible beep sounds. Clean up 

the spill or remove the object.

The cooking zones stop automatically if they are left

on for too long. Refer to the section, "operating time".

Frequency of on/off operations for cooking zones

The on-off cycles vary according to the required heat level:

- low level: short operating time,
- high level: long operating time.

"H" display, residual heat indicator, blinking.

The electronic temperature is too high. A technician should       

verify the fitting in compliance with the recommendations.

10. AFTERCARE

Before calling out a Service Engineer please check the 
following:

— that the plug is correctly inserted and fused; 
If the fault cannot be identified switch off the appliance — do not 
tamper with it — call the Aftercare Service Centre. The appliance 
is supplied with a guarantee certificate that ensures that it will be 
repaired free of charge at the Service Centre.

11. PROTECTION OF THE ENVIRONMENT

This appliance is marked according to the 
European directive 2012/19/EU on Waste 
Electrical and Electronic Equipment (WEEE). 
WEEE contains both polluting substances 
(which can cause negative consequences for 
the environment) and basic components (which 
can be re-used). It is important to have WEEE 
subjected to specific treatments, in order to 
remove and dispose properly all pollutants, and 

recover and recycle all materials.
Individuals can play an important role in ensuring that WEEE 
does not become an environmental issue; it is essential to follow 
some basic rules:
• WEEE shall not be treated as household waste.
• WEEE shall be handed over to the relevant collection points 
managed by the municipality or by registered companies. In 
many countries, for large WEEE, home collection could be 
present.
• When you buy a new appliance, the old one may be returned to 
the retailer who has to collect it free of charge on a one-to-one 
basis, as long as the equipment is of equivalent type and has the 
same functions as the supplied equipment.

11 GB- IE