Beurer LB 55 - Инструкция по эксплуатации - Страница 17

17

Clean before using for the first time

For reasons of hygiene, we recommend rinsing the air humidifier, water tank and pad [4] thoroughly with 

cold water before using for the first time. Then proceed as described in the “Cleaning the device” section of 

chapter 8 “Cleaning and storage”.

Filling the tank

Fill the tank when putting the appliance into operation for the first time or if the red indicator [A] is illuminated, 

indicating that the water level is too low.

 IMPORTANT

•  Only ever use fresh tap water to fill the tank [8].

•  Never put any additives into the water.

•  Make sure that the tank catch [9] with seal on the base of the water tank [8] is tightly fastened before 

putting the appliance into operation.

•  Remove the cover [2] from the air humidifier.

•  Pull the water tank [8] out of the air humidifier using the handles [7]. Unscrew the tank catch [9] from 

the tank [8].

•  Rinse out the water tank [8] with clean water.

•  Fill the water tank [8] with cold tap water.

•  Screw the tank catch [9] onto the water tank [8]. Place the water tank [8] in the air humidifier.

•  Place the cover [2] on top of the air humidifier.

Air humidifier placement

 Caution

Place the appliance so that the steam nozzle [1] is not pointing directly at a wall. The exiting moisture might 

otherwise cause damage to walls, particularly to wallpaper.

• Place the air humidifier on a firm, even, water-resistant surface.

• Position the mains cable [11] so that the appliance cannot be knocked over.

7. Operation

IMPORTANT

Check the humidity of your ambient air regularly. Intensive continuous operation can cause the am-

bient air to become excessively humid. The relative air humidity should not exceed 60%.

Switching on the device

 IMPORTANT

•  Never switch on the air humidifier without the water tank [8] or steam tower [3].

•  Insert the plug into the mains socket.

•  Press the ON/OFF button [D] in order to switch on the air humidifier. The green indicator [B] is illu-

minated.

•  Before the steam starts exiting: Rotate the steam nozzle [1] so that the steam exits in the required 

direction.

•  After a few minutes, the appliance starts to give off steam. The green indicator [B] is illuminated while 

the appliance is switched on and connected to the mains.

Selecting the amount of steam

• Select the amount of steam using the steam button [C] . 

Level 1: minimum steam (approx. 200 ml/h) 

Level II: maximum steam (approx. 400 ml/h)

After a few minutes, the appliance alters the amount of steam generated.