Увлажнители Timberk THU UL 24 E - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.

www.timberk.com •
electric humidifier
7
9. TROUBLESHOOTING
In case of emergency, please, use the troubleshooting methods shown in
tables. If it is impossible to solve problems with these methods, apply to
the service center.
Problem
Possible cause
Remedy
Poor atomizing (insufficient
capacity)
The unit is operating in the minimized
mode (low atomizing frequency)
There is no problem. If you need to switch
to the intensive mode of operation, turn the
regulator handle all the way to the right.
The atomizer is clogged
Clean the atomizer.
Temperature of water in the tank is too low
Set maximum capacity. The humidifier’s
capacity will go up after a while.
No atomizing
The power cord is poorly connected
to the outlet
Connect the power cord into the outlet
carefully
There is white deposit on objects
around the humidifier (salts,
separating out from water)
1. Lime deposits have formed on the
membrane
2. There is a lot of salts in the water used
(calcium and magnesium)
1. Clean the humidifier’s membrane with a
special brush
2. Use filtered water
Steam has an unpleasant odor
Stale water is used
Clean the unit according to the cleaning
and servicing instructions and fill the tank
with fresh water
Remains of stale water or waste have
accumulated in the unit’s case or the
atomizer
Condensate is formed on the
upper part of the humidifier and
on surrounding objects, when it is
operating.
1. High humidification intensity is set.
2. High room humidity and temperature.
Lower the humidification intensity by
turning the on/off and steam outflow
intensity regulator counterclockwise.
Water appears next to the humidifier,
when it is operating.
1. High humidification intensity is set.
2. Lime deposits have formed on the
membrane and in grooves for water (in
the unit’s base).
1. Lower the humidification intensity by
turning the on/off and steam outflow
intensity regulator counterclockwise.
2. Clean the unit according to the cleaning
and servicing instructions.
Water appears next to the humidifier,
when it is not operating
Water tank is leaking
You need to contact an authorized service
center
Содержание
- 8 СОДЕРЖАНИЕ; Уважаемый покупатель!
- 9 ПРАВИЛА БЕЗОПАСНОСТИ
- 10 ТЕХНИЧЕСКИЕ ХАРАКТЕРИСТИКИ
- 11 НАПОЛНЕНИЕ РЕЗЕРВУАРА ВОДОЙ; Снимите распылитель с резервуара, после чего резервуар для
- 12 ЭКСПЛУАТАЦИЯ ПРИБОРА
- 13 ОЧИСТКА И ОБСЛУЖИВАНИЕ
- 14 ПОИСК И УСТРАНЕНИЕ НЕИСПРАВНОСТЕЙ; В случае возникновения аварийных ситуаций обращайтесь к спосо
- 17 гарантийный талон; Гарантийные обязательства; изделия, купленные на территории РФ и изготовленные для РФ.
- 20 Заполняется фирмой-продавцом; Без подписи покупателя Гарантийный талон является недей-; Подписывая данных гарантийный талон, Покупатель признает, что
- 22 Заполняется сервисным центром
- 23 сообщите нам об этом, связавшись с нами по электронной почте,