Timberk THU UL 23 E (BL) - Инструкция по эксплуатации - Страница 7

7

www.timberk.com • ultrasonic humidifier

7

Table 2

Problem

Possible cause

Remedy

Poor atomizing (insufficient 

capacity)

The unit is operating in 

the minimized mode (low 

atomizing frequency)

There is no problem. If 

you need to switch to 

the intensive mode of 

operation, turn the regulator 

handle all the way to 

the right.

The atomizer is clogged

Clean the atomizer.

Temperature of water in the 

tank is too low

Set maximum capacity. The 

humidifier’s capacity will go 

up after a while.

No atomizing

The power cord is poorly 

connected to the outlet

Connect the power cord into 

the outlet carefully

There is white deposit 

on objects around 

the humidifier (salts, 

separating out from water)

1. Lime deposits have 

formed on the membrane

2. There is a lot of salts in 

the water used (calcium and 

magnesium)

1. Clean the humidifier’s 

membrane with a special 

brush

2. Use filtered water

Steam has an unpleasant 

odor

Stale water is used

Clean the unit according to 

the cleaning and servicing 

instructions and fill the tank 

with fresh water

Remains of stale water or 

waste have accumulated 

in the unit’s case or the 

atomizer

Condensate is formed on the 

upper part of the humidifier 

and on surrounding objects, 

when it is operating.

1. High humidification 

intensity is set.

2. High room humidity and 

temperature.

Lower the humidification 

intensity by turning the 

on/off and steam outflow 

intensity regulator 

counterclockwise.

Water appears next to 

the humidifier, when it is 

operating.

1. High humidification 

intensity is set.

2. Lime deposits have 

formed on the membrane 

and in grooves for water (in 

the unit’s base).

1. Lower the humidification 

intensity by turning the 

on/off and steam outflow 

intensity regulator 

counterclockwise.

2. Clean the unit according 

to the cleaning and 

servicing instructions.

Water appears next to the 

humidifier, when it is not 

operating

Water tank is leaking

You need to contact an 

authorized service center

Temperature 

requirements*

Humidity 

requirements*

Transportation

and storage

-30 °C to +50 °C

15 % to 85 %

(no condensate)

We are researching new technologies and constantly improving 

the quality of our products. Specifications, design and scope 

of delivery may be changed without any prior notice.

1. When transporting, any possible impacts and movements 

of the package inside a vehicle must be avoided. 
2. Handling symbols on the unit’s package must be strictly 

observed when transporting and storing it.
3.

11. TRANSPORTATION AND STORAGE

* Products must be stored in dry, ventilated storages at the 

temperature not lower than -30°C.

Service life of the humidifier is 2 years.
At the end of its service life the humidifier should be utilized 

in accordance with regulations and procedures, which are 

in force at the place of utilization.

12. UTILIZATION