Timberk THU UL 23 E (BL) - Инструкция по эксплуатации - Страница 6

www.timberk.com • ultrasonic humidifier

6

«Filling the reservoir with water», then connect the device to the 

electrical network.

Aroma

The device is equipped with aroma capsules. When you add 

aromatic oil to it, air is aromatized. Aromatic oil is not included 

in the scope of supply.

Switching off the device

To turn off the device, press the button on the control panel 

several times, the device will turn off, and the indicator on the 

control panel will turn off.

Before cleaning the device make sure that the plug is 

disconnected from the wall outlet. Otherwise, it may result in 

electric shock. Before cleaning, wait until the cooling water in the 

ground, so as not to burn your hands. Spend device cleaning 

once or twice a week. To clean the outer surface of the unit with 

a damp soft cloth. To avoid electric shock, do not scratch or 

damage the device while cleaning elements.

Do not use when cleaning the device thinner, benzene, dimethyl 

benzene, stiff brush, talcum powder and other materials, except 

water.

Wipe any remaining water inside the base with a damp, soft 

cloth.

To remove the remaining water in the small details, you can use 

a soft brush, then wipe it again with a soft cloth.

In the formation of dirt on the membrane, clean it with a soft 

brushes. Use a soft brush to erase the remnants of water on the 

surface of the device, and then wipe it again with a soft cloth. 

Rinse water tank and a clean water dispenser.

After removal of the residual water from the surface of the 

sprayer, wipe it with a soft cloth. Clean the outside surface with 

a damp, soft cloth.

8. CLEANING AND MAINTENANCE

IMPORTANT!  
To avoid deformation or wear of working 

surfaces, resulting in decreased atomizing 

or other malfunctions, do not use metallic 

brushes, blades or talc powder to wipe the 

atomizer’s surface. The water tank may 

leak upon heavy impacts. In case of water 

leakage, immediately stop using the unit and 

contact a service center. To keep the unit dry, 

remove water after cleaning and make sure 

to dry the unit’s case. Make sure that there 

is no water left inside the unit’s case. Prior to 

a long break in using the unit, dry its surface 

and pack it into a plastic bag, then put it into 

a box. Store the unit in a low-humidity room. 

Storing the unit undried results in generation 

of mold.

In case of emergency, please, use the troubleshooting 

methods shown in tables. If it is impossible to solve 

problems with these methods, apply to the service center.

10. TROUBLESHOOTING