Timberk THU UL 08 - Инструкция по эксплуатации - Страница 7

www.timberk.com • электрический увлажнитель воздуха

7

1. When transporting, any possible impacts and movements of the 

package inside a vehicle must be avoided.
2. Handling symbols on the unit’s package must be strictly observed when 

transporting and storing it.

9. TRANSPORTATION AND STORAGE

In case of emergencies use troubleshooting methods, listed in Table 2, 3. 

If it is impossible to remedy problems by the listed methods, contact the 

manufacturer’s service center.

10. TROUBLESHOOTING

IMPORTANT! 

To avoid deformation or wear of working surfaces, 

resulting in decreased atomizing or other malfunctions, 

do not use metallic brushes, blades or talc powder to 

wipe the atomizer’s surface.
The water tank may leak upon heavy impacts.
In case of water leakage, immediately stop using the 

unit and contact a service center.
To keep the unit dry, remove water after cleaning and 

make sure to dry the unit’s case.
Make sure that there is no water left inside the unit’s 

case.
Prior to a long break in using the unit, dry its surface 

and pack it into a plastic bag, then put it into a box.
Store the unit in a low-humidity room.
Storing the unit undried results in generation of mold

Temperature 

requirements*
Humidity 

requirements*

We are researching new technologies and constantly improving the quality 

of our products. Specifications, design and scope of delivery may be 

changed without any prior notice.

* Products must be stored in dry, ventilated storages at the temperature not lower than -30°C

Transportation and 

storage

 -30°С to +50°С

15% to 85% 

(no 

condensate)

cools down, to avoid getting burned.

Use a damp and soft fabric to wipe the unit’s external surface.

To avoid electric shock do not scratch or damage elements of the unit 

when cleaning.
When cleaning, do not use solvents, benzene, xylene, scrub brush, talc 

powder and other substances except for water.

Wipe off remains of water inside the unit’s case using a damp and 

soft fabric.

To wipe of remains of water on small parts you can use a soft brush and 

then wipe them with a soft fabric again.
Clean the unit once or twice a week.

In case of dirt on the membrane, clean it with a brush.

Clean the unit once or twice a week.

Clean the water tank and the atomizer with clean water.

Clean the cover carefully and lightly, otherwise it may cause water leaks 

through the cover.
After removing water from the atomizer’s surface clean it with a soft fabric.
Clean the unit’s external surface with a damp and soft fabric.

Table 2

Problem

Possible cause

Remedy

Poor atomizing
(insufficient capacity)

The unit is operating in the minimized 
mode (low atomizing frequency)

There is no problem. If you need 
to switch to the intensive mode of 
operation, press  «      » button and 
select the necessary steam outflow 
intensity.

The atomizer is clogged

Clean the atomizer

Temperature of water in the tank 
is too low

Set maximum capacity. The 
humidifier’s capacity will go up 
after a while.