Timberk THU UL 08 - Инструкция по эксплуатации - Страница 6

www.timberk.com • электрический увлажнитель воздуха

6

Prior to cleaning the unit make sure the power supply’s plug is disconnected 

from the outlet. Otherwise, it may cause electric shock.
Prior to cleaning wait until water, remaining in the unit’s case, completely 

8. CLEANING AND MAINTENANCE

IMPORTANT! 

To avoid electric shock, prior to disassembling the 

unit (removing the tank), disconnect the unit from the 

power line! Do not fill the tank with other liquids but 

tap water.
Different composition of liquids has harmful effect on 

internal parts and causes failures.
Do not fill the unit or the water tank with such 

additives as essential oils, fragrances, cleaning 

agents, chemical medical drugs, warm water (above 

40°), etc.
Otherwise, the water tank and internal parts of the 

unit will be damaged and inoperable.
Do not fill water directly into the internal part of the 

unit or the atomizer.
Water inside the unit may cause failure of the unit.
Do not hit or throw the water tank. It may get damaged 

resulting in water leaks. Do not use the unit in case if 

the water tank is heavily hit.
Immediately contact the technical support service or 

the maintenance and repair station.
Every day fill the tank with fresh water and keep the 

unit clean.

7. OPERATION OF THE UNIT

Install the unit to a true vertical on an even and dry surface, then connect 

it to the power line, having filled the tank with water first, at the same time 

the «      » indicator will be blinking on the LCD display.
Press the «      » button and the unit will automatically start operating, and 

indicators will show up on the LCD display.
At the very beginning of operation, the atomizing level may appear 

unstable, which is caused by the temperature difference and water quality. 

It takes some time for water to start turning into steam on the ultrasonic 

membrane. After 10-25 minutes the atomizing level will gradually stabilize.
To select the operation mode and change the steam outflow intensity press 

the «      » button several times, the steam outflow intensity will be changed 

each time and shown on the display by indicators.
The display shows the current humidity level and temperature.
The unit will be turned off if water is completely used up, at the same time 

the no water indicator «      » will light up.
To continue operation of the unit, add water in accordance with the 

instructions (section 6 Filling the tank with water).
In the automatic operation mode (A indicator) the steam outflow intensity 

will be adjusted automatically.
If the relative humidity level is less than 40% then the humidifier will operate 

in the 6th steam outflow intensity mode.
If the relative humidity level is 40% to 50% then the humidifier will operate 

in the 4th steam outflow intensity mode.
If the relative humidity level is 50% to 60% then the humidifier will operate 

in the 3rd steam outflow intensity mode.
If the relative humidity level is over 60% then the humidifier will operate in 

the 1st steam outflow intensity mode.
The unit is equipped with a compartment for aromatic oil. If aromatic oil is 

added to this compartment then there will be air aromatization. Aromatic 

oil is not included in the scope of delivery. To remove the compartment for 

aromatic oil press button 7 (see Fig. 1).
To turn off the unit press the «      » button.

NOTE:

When using the humidifier, you may come across 

condensate generation on its upper part and objects 

next to it, including water accumulation, which is not 

a defect, but a feature of its operation. This feature 

may have several causes, listed in table 2 on page 7.