Ardesto IR-B2235 - Инструкция по эксплуатации - Страница 18

19

EN

•  Slowly pour the water into the reservoir using the special measure and taking 

care not to go over the maximum level (about 450 ml) indicated by “MAX” on 

the reservoir 

[Fig. 2]

.

•  Close the water inlet cover (B).

Setting the temperature

•  Put the iron in a vertical position.

•  Put the plug in the socket.

•  Adjust the temperature control dial (H) according to the international symbol 

on the garment label 

[Fig. 3

]. The plate temperature control light (F) indicates 

that the iron is heating up. Wait until the plate temperature control light goes 

off before ironing.

Warning:

during ironing, the light indicator (G) turns on periodically, indicating that 

the selected temperature is maintained. If you lower the temperature after ironing at 

a high temperature, do not start ironing until the indicator light goes out.

Setting the steam

The quantity of steam is regulated by the steam regulator (C).

•  Move the steam selector to a position between minimum and maximum 

depending on the quantity of steam required and the temperature selected 

[Fig. 1]

.

•  Set the steam regulator (C) to the desired position

Warning:

the iron gives off steam continuously only if you hold the iron horizontally. 

You can stop the continuous steam by placing the iron in a vertical position or by 

moving the steam regulator to the 

«OFF»

 position. As indicated on the temperature 

control dial (H) and in the initial table, you can only use steam at the highest 

temperatures. If the selected temperature is too low, water may drip onto the plate.

CAUTION: If the steam iron has been used for a long time, it can be hot and 

there is no water in the water tank. Do not refill it with water until the steam 

iron cools down.

SETTING SHOT-STEAM AND STEAM WHEN IRONING VERTICALLY

Press the burst steam button (E) to generate a powerful burst of steam that can 

penetrate the fabrics and smooth the most difficult and tough creases. Wait for a 

few seconds before pressing again 

[Fig. 4]

.

By pressing the shot-steam button at intervals you can also iron vertically 

(curtains, hung garments, etc.) 

[Fig. 5

].

Warning:

the shot-steam function can only be used at high temperatures. Stop the 

emission when the plate temperature control light comes on, then start ironing again