Philips GC8328/02 - Инструкция по эксплуатации - Страница 13

Problem

Cause

Solution

Steam escapes 

from under the 

Calc-Clean rinsing 

cap when the 

appliance heats 

up.

You have not tightened the Calc-clean 

rinsing cap properly.

Switch off the appliance, tighten 

the Calc-Clean rinsing cap and 

switch on the appliance again. If 

steam continues to escape when 

the appliance is heating up, switch 

off the appliance and contact a 

ser vice centre authorised by 

Philips.

The iron does 

not produce 

enough steam/the 

amount of steam 

decreases and 

increases during 

steam ironing.

When the appliance pumps water into 

the steam generator, the steam amount 

sometimes decreases. This is probably 

when you think that the iron does not 

produce enough steam. However, this is 

a normal phenomenon and the steam 

output normalises within a few seconds.

To optimise the steam output, 

release the steam lock when you 

do not need steam and when you 

put down the iron.

Wet spots appear 

on the fabric 

during ironing.

The wet spots that appear on the fabric 

after you have steam ironed for some 

time may be caused by steam that has 

condensed onto the ironing board. Iron 

the wet spots without steam for some 

time to dr y them. If the underside of the 

ironing board is wet, wipe it with a piece 

of dr y cloth.

To prevent steam from condensing 

onto the ironing board, use an 

ironing board with a wire mesh 

top.

Water droplets 

come out of the 

soleplate when I 

use the shot-of-

steam function.

Steam may have condensed in the hose, 

the temperature may have been set 

below 

3

 or the appliance may not 

be ready for steam ironing.

Make sure the temperature is set 

to 

3

 or higher. Steam iron for 

a few seconds before you use the 

shot-of-steam function.

EnGlish

13

4239_000_7741_3_DFU-Booklet_A5_v2.indd   13

5-4-2011   10:27:27