Maxwell MW-3051BN - Инструкция по эксплуатации - Страница 9

9

ENGLISH

• 

This unit is not intended for usage by chil-
dren. Place the unit out of reach of children 
during operation and cooling down.

• 

The unit is not intended for usage by physi-
cally or mentally disabled persons (including 
children) or by persons lacking experience or 
knowledge if they are not under supervision 
of a person who is responsible for their safety 
or if they are not instructed by this person on 
the usage of the unit.

• 

Do not use the unit if the power cord or the 
plug is damaged, if the unit works improp-
erly or after it was dropped or in case of 
leakage.

• 

Do not attempt to repair the unit. Do not dis-
assemble the unit by yourself, if any mal-
function is detected or after it was dropped, 
unplug the unit and apply to any authorized 
service center from the contact address list 
given in the warranty certificate and on the 
website www.maxwell-products.ru.

• 

Transport the unit in the original package 
only.

• 

Keep the unit out of reach of children and dis-
abled persons.

THE UNIT IS INTENDED FOR HOUSEHOLD USE 
ONLY, ITS COMMERCIAL USAGE AND USAGE 
IN PRODUCTION AREAS AND WORK SPACES IS 
PROHIBITED.

BEFORE THE FIRST USE

After unit transportation or storage at low tem-
perature keep it for at least three hours at room 
temperature before switching on

.

• 

Unpack the iron; remove the protection from 
the soleplate (13), if any.

• 

Check the unit for damages, do not use the 
iron in case of damages.

• 

Before switching the iron on, make sure that 
your home mains voltage corresponds to the 
iron operating voltage.

• 

There may be water residue in the tank, this 
is normal, as the iron has undergone factory 
quality control.

Note

: While the first switching on the heating 

element of the iron burns, therefore occurrence 
of foreign smell and a small amount of smoke is 
possible, it is normal.

Control knobs, indications and symbols

• 

The continuous steam supply knob (3) has 
3  fixed positions:

– 

 – steam supply is off;

– 

 – steam supply is on;

– 

 – «double steam»

and one unfixed position:

– 

 – self-clean.

• 

Burst of steam button (4) – press the button to 
activate the additional steam supply function.

• 

Water spray button (5) – press the button to 
activate the water spray function.

• 

Heating element ON/OFF indicator (7) – 
when the indicator lights up, the iron sole-
plate is heating up.

• 

Temperature control knob (11) – allows to 
set the iron soleplate temperature depend-
ing on the type of fabric (see the table 
below). The knob is in the position «OFF» – 
the iron is off.

• 

«MAX» maximal water level mark

• 

The symbol 

 indicates hot surfaces.

WATER SELECTION

You can use tap water to fill the water tank (10). 
If tap water is hard, use distilled or demineralized 
water, this will prolong service life of the iron.

Note: 

Do not fill the water tank (10) with scent-

ed liquids, vinegar, starch solution, descaling 
reagents, chemical agents etc.

FILLING THE WATER TANK

Before filling the iron with water, make sure that 
it is unplugged.

• 

Set the temperature control knob (11) to the 
position «OFF», and the continuous steam 
supply knob (3) to the position 

– continu-

ous steam supply is off.

• 

Open the water inlet lid (2).

• 

Pour water into the water tank (10) and then 
close the lid (2) tightly.

Note:

• 

Do not exceed the «

MAX

» mark (12).

• 

If you need to refill water during ironing, 
always switch the iron off first and unplug it.

• 

After you finish ironing, switch the iron off, 
wait until it cools down completely, then open 
the water inlet lid (2), turn over the iron and 
drain the remaining water.

IM MW-3051.indd   9

10/4/17   11:45