JVC KS-F525 - Инструкция по эксплуатации - Страница 14

14

ENGLISH

Changing the display mode while
listening to an FM station

You can change the initial indication on the display
to station name (PS NAME), station frequency
(FREQ) or clock time (CLOCK), while listening to
an FM RDS station.
• See also “Changing the general settings (PSM)”

on pages 23 and 24.

1

Press and hold SEL (select) for more than 2
seconds so that one of the PSM items appears
on the display.

2

Press 

¢

 or 

4

 to select “DISPMODE

(display mode).”

3

Turn the control dial to set to the desired indication
(“PS NAME,” “FREQ” or “CLOCK”).

4

Press SEL (select) to finish the setting.

Note:

By pressing DISP (display), you can also change the
display while listening to an FM RDS station.
Each time you press the button, the following information
appears on the display:

•

Then, the display goes back to the original indication
in several seconds.

Setting the TA volume level

You can preset the volume level for TA Standby
Reception. When a traffic programme is received,
the volume level automatically changes to the preset
level.
• See also “Changing the general settings (PSM)”

on pages 23 and 24.

1

Press and hold SEL (select) for more than 2
seconds so that one of the PSM items appears
on the display.

2

Press 

¢

 or 

4

 to select “TA VOL

(volume).”

3

Turn the control dial to set to the desired volume.
You can set it from “VOL 00” to “VOL 50.”

4

Press SEL (select) to finish the setting.

Automatic clock adjustment

When shipped from the factory, the clock built in
this unit is set to be readjusted automatically using
the CT (Clock Time) data in the RDS signal.
I f   y o u   d o   n o t   w a n t   t o   u s e   a u t o m a t i c   c l o c k
adjustment, follow the procedure below.
• See also “Changing the general settings (PSM)”

on pages 23 and 24.

1

Press and hold SEL (select) for more than 2
seconds so that one of the PSM items appears
on the display.

2

Press 

¢

 or 

4

 to select “AUTO ADJ

(adjustment).”

3

Turn the control dial counterclockwise to select
“OFF.”
Now automatic clock adjustment is canceled.

4

Press SEL (select) to finish the setting.

To reactivate clock adjustment, repeat the same
procedure and select “ON” in step 3 by turning the
control dial clockwise.

Note:

It takes about 2 minutes to adjust the time using the CT
data. So, you should not change the station for more
than 2 minutes continuously; otherwise, the clock time
will not be adjusted.

Station name

(PS NAME)

Station frequency

(FREQ)

Programme type

(PTY)

Clock time

(CLOCK)