Триммеры Stiga SGT 500 AE 278100008/ST1 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
EN - 16
12. WARRANTY COVERAGE
The warranty covers all material and
manufacturing defects. The user must
follow all the instructions provided in
the accompanying documentation.
The warranty does not cover damage caused by:
•
failure to become familiar with the
documentation accompanying the machine;
•
carelessness;
•
incorrect or forbidden use or assembly;
•
use of non-genuine spare parts;
•
use of attachments not supplied or
not approved by the manufacturer.
The warranty does not cover:
•
normal wear and tear of consumables,
such as cutting means, safety
bolts; Normal wear and tear.
The purchaser is protected by his or her own
national legislation. The purchaser’s rights under
the national laws or his or her own country are
not in any way restricted by this warranty.
13. MAINTENANCE TABLE
Intervention
Frequency
Notes
MACHINE
Check all fasteners
Before each use
par. 7.4
Safety checks/check controls
Before each use
par. 6.2
Check the cutting means guard.
Before each use
par. 6.2.1
Checking the cutting means
Before each use
par. 6.2.1
Check the battery charge status
Before each use
*
Recharge the battery
After each use
par. 7.2.2
*
Cleaning the machine and the motor
After each use
par. 7.3
Checking for any damage to the machine. If
necessary, contact the authorised service centre.
After each use
-
* Refer to the battery/battery charger manual.
14. TROUBLESHOOTING
PROBLEM
PROBABLE CAUSE
SOLUTION
1.
The cutting means
is stationary and the
machine does not start
when the throttle control
lever and throttle safety
lever are engaged
Battery is not inserted or
is inserted incorrectly
Make sure that the battery is
inserted well (par. 7.2.3)
Low battery
Check the battery status and
recharge if necessary (par. 7.2.2)
The separable rod was not fully or
properly inserted in its housing
Make sure the separable rod was
installed
and correctly inserted (par. 4.2)
Defective throttle control lever/
throttle safety lever
Do not use the machine. Immediately
turn off the machine remove the battery
and contact a service centre.
Machine damaged
Do not use the machine. Immediately
turn off the machine remove the battery
and contact a service centre.
2. Motor overheating
Grass caught under the
cutting means guard
Remove caught grass (par. 6.5)
3. Grass accumulates
around the power
unit housing and the
cutting line head
Too high grass is being cut
close to the ground
Cut tall grass with a top down
movement to avoid accumulations.
