Caso HW 600 - Инструкция по эксплуатации - Страница 35

35 

Please note 

► If only a small amount of water is dispensed, then the desired temperature may differ. 

Preheat the vessel. 

► If device was not used for longer time there could be scale deposits despite water filter. In 

this case let 100 ml with 100 °C run through the device. 

► The device has a memory function if the plug is still plugged in. The settings, that were 

adjusted the last time, are still adjusted. The settings will be reset after unplugging. 

► The ambient temperature changes everyday. This leads to different 

amounts of water. It can vary up to +- 15%. 

14.2.1 

Water disposal from the drip tray 

1.  When the drip tray is full, grasp and stabilize the device by one hand 

and use the other hand to lift up the drip tray slightly to remove it.  

2.  Empty the drip tray and insert it into the original place. Make sure it is 

properly inserted.  

14.2.2 

Replacing the waterfilter 

1.  Open the tank cover (A) and take out the filter 
box (B) with the old waterfilter (C). 
 
2.  Soak the new waterfilter upright in water for 10 
min. 
3.  Rinse the new waterfilter thoroughly under 
running water. 
4.  Remove the old waterfilter and replace it with 
the new waterfilter (see fig.). Therefor take out the 
filter box, place the new waterfilter and pull it down 
from the bottom.  
 
 

14.2.3 

Error code Lo Lack of water 

If the device stops to operate with a beeping sound and the display shows the error code 

Lo 

Lack of water,

 it means that there is too little water or no water in the water tank. Please fill 

in enough water into the water tank immediately. 

14.2.1 

Calibration 

If you want to optimize the temperature or volume of water, then you can calibrate the device. 
Fill the tank up to max marking. 
Place vessel below the spout which can collect whole content of watertank. 

Press and hold 

Temp-button 

for 3 seconds until „CAL“ is displayed. When volume 

“000” is shown press 

Start/Stop

 for confirmation. The device perfoms the calibration and 

beeps once process is finished.