Caso HW 600 - Инструкция по эксплуатации - Страница 30

30 

12.3  Unpacking 

To unpack the device, proceed as follows: Remove the device out of the carton and remove 
the packaging material. 

12.4  Disposal of the packaging 

The packaging protects the device against damages during transit. The packaging materials 
are selected in accordance with environmentally compatible and recycling-related points of 
view and can therefore be recycled. Returning the packaging back to the material loop saves 
raw materials and reduces the quantities of accumulated waste.  
Take any packaging materials that are no longer required to “Green Dot” recycling collection 
points for disposal. 

12.5  Setup location requirements: 

In order to ensure the safe and trouble-free operation of the device, the setup location must 
fulfil the following prerequisites: 



  The device must be set up on a firm, flat, horizontal surface with sufficient load-bearing 

capacity for the device. 



  Place the device only on a waterresistent surface. 



 Do not use the device outdoors.  



  The device is not intended to be installed in a wall or a built-in cupboard. 



  Do not operate the product near hot gas or hot stove. 



  Choose the setup location in such a way that children cannot reach the device. 



  The device is not intended to be installed in a wall or a built-in cupboard. 



  Do not set up the device in a hot, wet or extremely damp environment or near flammable 

material. 



  The electrical socket must be easily accessible so that the power lead can be 

disconnected easily, in the case of an emergency. 



  The installation and assembly of this device in non-stationary setup locations (e.g. on 

ships) must be carried out by specialist companies / electricians, provided they guarantee 
the prerequisites for the safe use of this device. 

12.6  Electrical connection 

In order to ensure the safe and trouble-free operation of the device, the following instructions 
must be observed for the electrical connection: 



  Before connecting the device, compare the connection data (voltage and frequency) on 

the rating plate with those of your electrical network. This data must agree in order that no 
damages occur in the device. If in doubt, ask your qualified electrician. 



  The connection between the device and the electrical network may employ a 3 meter long 

(max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or gangs 
is prohibited because of the danger of fire that is involved with this. 



  Make sure that the power cable is undamaged and has not been installed under the ice 

maker or over hot or sharp surfaces. 



  The electrical outlet must be protected by a 16A safety cut-out switch. 



  The electrical safety of the device is only guaranteed if the device is connected to a 

properly installed protective conductor system. If in doubt, have the house installation 
checked over by a qualified electrician. The manufacturer cannot be made responsible for 
damages that are caused by a missing or damaged protective conductor.