Brayer BR1092 (MULTI) - Инструкция по эксплуатации - Страница 7

7

EN

THERMOPOT IS INTENDED FOR HOUSEHOLD USE 

ONLY, DO NOT USE THE COFFEE MAKER FOR 

COMMERCIAL OR LABORATORY PURPOSES.

BEFORE USING THE THERMOPOT
After unit transportation or storage at low 

temperature keep it for at least 3 hours at room 

temperature before switching on.

•  Unpack the thermopot and remove all the packaging 

materials.

•  Keep the original package.

•  Read the safety measures and operating 

recommendations.

•  Check the delivery set.

•  Examine the thermopot for damages, in case of 

damage do not plug it into the mains.

• 

Make sure that the specifications of power supply 

voltage specified on the label correspond to the 

specifications of your mains. When using the 

thermopot in the mains with 60 Hz frequency, the unit 

does not need any additional measures.

•  Wipe the outer surface of the unit body (10) with a 

clean, slightly damp cloth to remove dust.

•  Open the lid (4) by pressing the button (5) and 

holding it (pic. 1).

• 

Wipe the inner surface of the thermopot flask with a 

clean, slightly damp cloth to remove dust. Close the 

lid (4).

SWITCHING THE THERMOPOT FOR THE FIRST 

TIME AND USING THE UNIT

• 

Place the thermopot on a dry flat surface keeping at 

least 20 cm gap between the thermopot body and 

the wall or furniture and at least 50 cm gap above the 

thermopot.

•  Open the lid (5) by pressing the button (5) and 

holding it (pic. 1).

•  • Fill the thermopot with water using a suitable bowl, 

do not exceed the maximal water level mark (14) 

«FULL» (pic. 2). Do not fill the thermopot with water 

directly from the faucet; to fill the thermopot use a 

suitable bowl.

Notes:

 to reduce the mineral deposit (scale), we 

recommend using the water cleaned with domestic 

filters.

•  Close the lid (5) until the lock clicking, make sure that 

the lid (5) is closed.

Notes:

 when using the thermopot, always check the 

sealing gasket (13). If you find any cracks on the sealing 

gasket (13), stop using the thermopot and apply to the 

service center to replace the gasket (13).
•  Insert the power cord (20) jack into the connector 

(11) on the thermopot body, and the 

•  power cord (20) plug into the mains socket.

•  The boiling mode indicator «Boiling» (16) will light up 

on the control panel (3) and the keep warm indicator 

(17) «Keep warm» will light up.