Hyundai Electronics H-LCD3200 - Инструкция по эксплуатации - Страница 11

11

During searching, press MENU button to quit the automatic search and go back to the previous menu.
Automatic searching starts from Channel 1, all the searched channels will be stored automatically. Dur-
ing searching, the modes of color and sound are automatically stored, thus to make sure the searched
channel later can be played correctly.
After  automatic  search  has  been  compete,  or  the  capacity  of  storing  236  channels  has  been  used  up,  or
the MENU button is pressed during searching, the system will quit from automatic searching mode and
go back to the previous channel setting menu and switch to Channel 1 automatically.
Manual search. In TV mode, press V+/V- buttons to search the signal upwards or downward, the system
will stop after one channel is searched, the current channel can be stored through pressing OK button. If
you  are  still  going  to  search,  you  can  press  V+/V-  buttons.  During  searching,  the  system  will  quit  the
manual searching and will be back to the settings before the searching, also, you can watch the program
by directly inputting the corresponding frequency number through the number buttons, but you have to
be sure the number input is within the range of the system, otherwise, the input will be invalid.
AFT.  In  TV  mode,  select  Fine  tuning,  press  V+/V-  buttons  to  finely  tune  the  frequency  and  to  turn
on/off the automatic frequency tracking, the searched program will be stored automatically after tuning.
Label.  Select  this  item,  press  OK  button  or  V+/V-  buttons  to  enter  submenu  to  edit  the  name  of  each
channel, select the character by P+/P- buttons, press V+/V- buttons to edit the next character after the
previous  character  edition  is  complete,  operate  by  this  way  until  the  whole  edition  is  complete.  Press
OK button or MENU button to save the settings and go back to the previous channel setting menu.
Program  Edit.  In  TV  mode,  select  the  channel  sorting  item,
press OK button or V+/V- buttons to enter into editing
mode as described in the following picture.

Press P+/P- buttons to highlight the channel you wish to edit,
the operation sequence is to press V+ button to confirm, and
then press P+/P- buttons to select the position you wish to put
the channel in, then press V- button to finish the channel se-
quencing operation. If this channel is your favorite channel, you

can add the mark “

” to the channel as your favorite channel

by press GREEN color button.

Note:

In AV, SVIDEO, COMPONENT, PC and HDMI mode,

there is no channel setting information.

Information of “SETUP” displayed in AV and SVIDEO mode.

Color  System.  You  can  select  AUTO  to  allow  the  system  to  identify  the  color  mode  automatically  or
choose the color mode by yourself if the video color is not right.

Information of “SETUP” displayed in VGA mode

Auto Adjust. Automatic position and  effect  adjustment  of the picture. If the picture position is not so
good, you can select this function.
Phase. Phase adjustment of the picture: in VGA mode, this function can be worked when there is any
abnormality of pictures.
H Position. Moving the picture horizontally through V-/V+ buttons.
V Position. Moving the picture vertically through V-/V+ buttons.