Telefunken TF-LED32S41T2 - Инструкция по эксплуатации - Страница 8

Operation

8

8

Operation

General operations

Power

•

Connect the plug of the power cord to the

mains socket.

• Do not leave your TV in standby mode for

a long period of time; if you are not going to 
use the unit, disconnect it from power supply.

• In TV mode the unit will automatically go to

standby mode if no signal for 

10

 minutes. 

Operations

• Press VOL- button repeatedly to decrease

the volume; press VOL+ button repeatedly to 
increase the volume.

• Press

MUTE

 to mute sound, press this button 

again or increase volume to resume sound.

• Press 

RECALL

 button on the RC to select

from the present channel and the previously 
displayed channel.

• Select the TV function mode. Press

CH-/CH+ buttons to select previous or next 
channels; or press number buttons to enter a 
channel number directly.

• Press INFO button to display the preset

TV channel play information.

• Press 

FREEZE

 button to freeze the picture on

or off.

• Press 

AUDIO

 button in TV mode repeatedly to

switch between various Nicam sound modes 
(can be unavailable for some channels). This 
function is optional.

Signal sources

Press 

 button, then press DOWN/UP 

cursor buttons on the RC or CH+/CH- 
buttons on the panel to select a source from 
available

source  list: 

DTV  =>  ATV  => 

SCART  =>  YPbPr  =>  PC  =>  HDMI1  => 

HDMI2 => AV => USB 

 Press OK button on the RC to confirm.

Teletext operations 

(option)

Select a TV channel in order to pick up 

the picture signal of Teletext. Teletext button 
functions are as follows:

TTX: Press this button to enter into TEXT 

mode. Press the button again to return to the 
channel you are watching.

HOLD: Press this button to stop the move 

to the next page. Press this button again to 
cancel operation.

INDEX: Press this button to go to the index 

page.

LIST: Toggle the list mode.
REVEAL: Press this button to reveal the 

concealed information. Press this button again 
to conceal the information.

Red/Green/Yellow/Blue buttons: Press 

these 4 color buttons to access directly to 
corresponding color page displayed at the 
lower parts of teletext screen.

Changing the battery

1. Remove the battery compartment cover

on the back of the RC.

2. Insert the batteries into the battery

compartment making sure that the correct 
polarity is observed.

3. Install the cover back.

1

2

3

• Use two AAA batteries for the RC. The RC

should be pointed at remote sensor within 8 
meters and within 30 degrees at the left or the 
right side.

• Take the battery out of the RC if it is not

used for a long time.

• Do not mix new and used batteries or

different types of batteries. Weak batteries can 
leak and severely damage the RC.

• Do not expose the RC to shock, liquids,

and do not place it in an area with high 
humidity.