TCL Q55C728 - Инструкция по эксплуатации - Страница 6

6

Chapter 2

Getting Started

Switching On

Follow the instructions on this page on how to switch on your TV set 

and the remote control before going on to following pages describing 

how to use the channel set-up procedure.

1. 

Insert two AAA batteries in the remote control. 
Precautions on using batteries:

- Only use the battery types specified.

- Make sure you use the correct polarity.

- Do not mix new and used batteries.

- Do not use rechargeable batteries.

- Do not expose batteries to excessive heat such as sunshine, 

fire or the like, throw them in a fire, recharge them or try to open 

them, as this could cause them to leak or explode.

- Remove the batteries from the remote control if you are not using 

it for a long period of time.

- Attention should be drawn to the environmental aspects of battery 

disposal.

2. 

Connect the power cable FIRST to the television, THEN to a mains 

socket. (

Note

: 

If the power cable is connected to the television, 

please only connect the power cable to the mains socket.

)

Your TV set should only be connected to an AC supply. It must not 

be connected to a DC supply. If the plug is detached from the ca-

ble, do not, under any circumstances, connect it to a mains socket, 

as there is a risk of electric shock.

Note

: 

The figures are for representation only, the location of power 

socket of the television may differ depending on the model.

3. 

Connect an outside aerial to the 

Antenna/Cable input

 socket at 

the back of the TV set. 
The aerial socket (75 OHM - VHF / UHF / cable) can be used for 

connecting an external aerial or other equipment fitted.

Notes

:

- 

If you want to receive the signal from your cable or cable box, 

please connect a coaxial cable to the 

Antenna/Cable input

 socket 

at the back of the TV set.

- If you want to receive the signal from your satellite receiver, please 

connect a coaxial cable to the 

Satellite input

 socket at the back of 

the TV set.

4. 

When powered on, the TV will be turned on directly or be in 

standby mode.
If the power indicator lights up, the TV set is in standby mode. 

Press the    button on the remote control or on the TV set to turn 
on the TV.

Switching Off

•  To put the TV set into standby mode, press the    button on the 

remote control. The TV set remains powered up, but with low 

energy consumption.

•  To switch off the TV set, unplug the mains socket from the mains 

outlet.