Стиральная машина Saturn ST-WM0622 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
16
Important:
Do not try to open the door, when the washing cycle is not finished or power
supply is cut off during the washing cycle, because the temperature may be high
and you may be scalded.
Cleaning and Maintenance
Use Process
Disconnect the machine from the mains electricity supply and
withdraw the plug from the socket before cleaning the machine.
The washing machine must not be hosed down.
Cleaning the exterior
Clean the exterior with a mild non-abrasive cleaning agent or soap and water, using a
well wrung-out cloth. Wipe dry with a soft cloth.
Do not use solvents, abrasive cleaners, glass cleaners or all-purpose
cleaning agents. These might damage plastic surfaces and other
components because of the chemicals they contain.
The washing drum
Clean the drum every 3 months by using the “Anti-Bac" program.
Cleaning the drawer
Remove detergent residues regularly. Clear the drawer following these instructions:
• Pull out the drawer until a resistance is felt. Press down the release catch and at the
same time pull the drawer right out of the machine.
• Remove the siphon from compartment and clean it.
• Clean the dispenser using a brush and warm water.
Cleaning the drawer housing
Use a bottle brush to remove detergent residues inside the drawer housing.
17
Cleaning the water inlet filter
Use pointed nose pliers to withdraw the plastic filter.
Clean, put back and secure. This filter should be checked every 6 months or so, or
more often if there are frequent interruptions to the water supply.
The filter must be put back in place after cleaning.
Cleaning the drain pump filter
1. Disconnect the machine
from the mains electricity
supply and open the pump
cover with a screwdriver.
2. Place a container under
the pump. Unscrew and
remove the filter.
3.
Clean
the
filter
carefully.
The filter should be cleaned every 2 months or so, or when there is a
fault that the “Rinse” and “Spin” LEDs flicker.
Important:
If the machine is exposed to temperatures below 0
0
C, certain precautions should
be taken.
1. Turn off the water tap.
2. Unscrew the inlet hose.
