Indesit W 145 TX - Инструкция по эксплуатации - Страница 23

The washing machine
fails to fill with water.

Is the hose correctly
connected to the tap?

Is there a water shortage ?

T h e r e   c o u l d   b e   w o r k   i n
progress in your building or
street.

Is there sufficient water
pressure?

 The  autoclave

may be malfunctioning.

Is the tap filter clean?

 If the

water is very calcareous, or
if work has recently been
c a r r i e d   o u t   o n   t h e   w a t e r
piping, the tap filter could be
clogged with par ticles and
debris.

Is the rubber hose kinked?

The tract of the rubber hose
bringing water to washing
machine must be as straight
as possible. Make sure it is
not squashed or kinked.

The programme selector
knob keeps turning?

Wait a few minutes for the
drain pump to empty the
tub, 

switch the washer off,

select one of the symbols
stop/reset  , then switch it
back on. If the knob continues
to turn, call for assistance
b e c a u s e   i t   i s   s h o w i n g   a n
anomaly.

The washing machine
continuously fills and
drains water.

Is the drain hose positioned
too low? 

It must be installed

at a height ranging from 60 to
100 cm.

I s   t h e   e n d   o f   t h e   h o s e

immersed in water?

Does the wall drainage

s y s t e m   h a v e   a   b r e a t h e r
pipe?

 If the problem persists

even after these checks, turn
t h e   w a t e r   s u p p l y   o f f   t h e
m a c h i n e   a n d   c a l l   f o r
assistance.
If you live on an upper floor of
your building, there may be a
problem with your drain trap.
To   s o l v e   t h i s   p r o b l e m ,   a
s p e c i a l   v a l v e   m u s t   b e
installed.

Before calling, read the following

Troubleshooting

In most cases, when your washing machine fails to work, the problems arising
can be easily solved without  having to call for a technician. Before calling for
assistance, always check these points.

The washing machine
fails to start.

Is the plug correctly inserted
into the socket?

 It could have

been moved whilst cleaning.

Is there electricity in the
house?

A circuit breaker may have
switched off as a result of too
many electrical appliances
working at the same time. Or
maybe due to a general failure
in your entire area.

Is the washing machine
door closed properly?

F o r   s a f e t y   r e a s o n s ,   t h e
washing machine cannot work

if the door is open or not shut
properly.

I s   t h e   O n / O f f   b u t t o n
pressed?

If it is, then a programmed start
has been set.

Is the programmed start
knob, in the correct position
f o r   t h o s e   m o d e l s
concerned?

Is the water supply turned
on?

 For safety reasons, if the

washing machine does not
load water, it cannot start a
wash cycle.

RIGHT

      WRONG

Turn off the water
supply after use.
This will eliminate
the possibility of
leakage.

Always leave the
appliance door ajar
to avoid bad odours.

Clean the
appliance’s
exteriors gently.
To clean the
exteriors and the
rubber parts of the
appliance, always
use a soft cloth
dipped in warm and
soapy water.

Leave the washing
machine plugged in while
cleaning.
Even during maintenance,
the appliance should
always be unplugged.

Use solvents and
aggressive abrasives.
Never use solvents or
abrasives to clean the
external and rubber parts
of the washing machine.

Neglect the detergent
dispenser.
It is removable and can
easily be cleaned by
leaving it under running
water.

Go on holiday without
thinking about her.
Before leaving, always
make sure that the
washing machine is
unplugged and that the
water supply is turned off.

Instructions for installation and us

e

20

Simple: with the new Indesit technology,  you need less than
half of it, to get good results on twice as much!
This is why you cannot see the water through the door:
because there is little, very little of it, to respect the
environment yet without renouncing maximum cleanliness.
And, on top of that, you are also saving electricity.

But where did all the water go?