Indesit W 145 TX - Инструкция по эксплуатации - Страница 18

L

M

A

B

C

I

D

G

H

E

F

T h e   w a s h i n g   m a c h i n e   i s
e q u i p p e d   w i t h   a n   e x t r a
compartment 

4

 (provided as an

accessory) for the bleach, to be
inserted in compartment 

1

.

Easy iron

T h i s   f u n c t i o n   a l l o w s   y o u r
washing to come out of the
m a c h i n e   w i t h o u t   c r e a s e s ,
making it much easier to iron.
You can use it with programmes

3-4

 (Cotton), 

5-6

 (Synthetics)

and 

8-9

 (Delicates).

P r e s s   t h i s   b u t t o n   i n
programmes 

5-6-8-9

 and the

wash cycle will come to a stop
on symbol  

. You can comple-

te it by pressing button 

E

 again.

Important: 

this function should

not  be  used  when  button 

H

( s t a i n   r e m o v a l )   h a s   b e e n
pressed.

Extra Economy

Reduces water consumption
dur ing the r inse cycles. We
recommend that you use this
function only with small laundry
loads, dosing the detergent
propor tionally.

Rapid wash

This button reduces the length
o f   t h e   w a s h   p r o g r a m m e   b y
about  30%. It cannot be used
with special programmes (see
page 16) or those for wool and
silk.

Stain removal (see page 19)

Thanks to this command, the
washing machine will carry out
a more intensive wash that
optimises the  effectiveness of the

Here I’m in command

Understanding the control panel

Making the right choice is important. And it’s easy.

Programme selector knob
and programmed start

Use this knob to select the wash
programme.

Turn this knob clockwise only.

To select a programme, you
should turn the knob so that the
symbol/number  of the desired
programme is in line with the
pointer on the knob.
Now press on/off button 

I

 (position

I

), pilot lamp 

L

 will start flashing.

After 5", the setting will be
accepted, pilot lamp 

L

 will stop

flashing (staying lit) and the wash
cycle will begin.
Should you wish to interrupt the
programme in progress or set a
new one, select one of the
symbols 

(Stop/Reset) and wait

5" : when the cancellation has
been accepted, pilot lamp 

L

flashes, and you can then turn the
appliance off.
You can use this knob to delay
the appliance's operation.
Select one of the four delay time
positions, press the on/off button

I

 (position 

I

) and wait 5". The

setting has now been accepted
(pilot lamp 

L

 stays lit) and you can

select the programme you desire.

Pilot   lamp 

L

  has  a particular

flashing motion  (2" on and 4" off)
to indicate that a delayed   start
has been set.
During this phase, you can open
the appliance door and change
the  washing  load,  should  you
wish to do so.

After the wash cycle has been set
and accepted by the washing
machine, turning the knob will
have no effect (except for when
it is on position   Stop/Reset).

Temperature control knob

It is used to set the wash tempe-
rature in the recommended
programme table on pag. 16. It
also allows you to reduce the tem-
perature recommended for the
selected programme, and even to
set a cold wash cycle (

).

Spin exclusion knob

It is used to exclude the spin
cycle (by choosing symbol  )
or to reduce the spin speed of
the selected programme. The
maximum speed for the four
types of fabric are:

Fabric

Speed

Cotton

1400 rpm

Synthetics

800 rpm

Wool

600 rpm

Silk

no

Note:

 distribution phase will be

carried out at low speed.

Detergent dispenser

I t   i s   d i v i d e d   i n t o   t h r e e
compartments:
1. Detergent for pre-wash;
2. Detergent for the main cycle

wash;

3. Fabric conditioner.

The detergent dispenser with the
additional  bleach compartment
is here.

15

Instructions for installation and use

1

2

3

4

liquid additives, thus allowing
m o r e   r e s i s t a n t   s t a i n s   t o   b e
removed. When you press the
stain removal button, you cannot
activate the pre-wash.

On-off

When button

 I 

is pressed, the

washing machine is switched
on, when it is not the machine
is switched off.

Tu r n i n g   t h e   a p p l i a n c e   o f f
does not cancel the selected
programme.

The on-off lamp

L a m p  

L  

f l a s h e s   w h e n   t h e

appliance is switched on and
awaiting a programme to be set.
A   s t e a d y   l i g h t   m e a n s   t h e
appliance has accepted the
selected programme.

The door block lamp

The safety lamp indicates that the
washing machine door is locked
to prevent it from being opened
a c c i d e n t a l l y.  To   avo i d   a ny
damages to lock mechanism,
you must wait for the lamp to
extinguish, before attempting to
open the door which takes around
three minutes.