Electrolux EWT 2852 EWW - Инструкция по эксплуатации - Страница 19

Problem

Possible solution

The appliance does not

drain the water.

• Make sure that the sink spigot is not clogged.

• Make sure that the drain hose has no kinks or bends.

• Make sure that the connection of the drain hose is cor‐

rect.

• Set the drain option if you set a programme without

drain phase.

• Set the drain option if you set an option which ends with

water in the drum.

• Make sure that the drain filter is not clogged. Clean the

filter, if necessary. Refer to 'Care and cleaning'.

• If problem remains please contact the Authorised Serv‐

ice Centre.

The spin phase does

not operate or the

washing cycle lasts lon‐

ger than usually.

• Set the spin option.

• Set the drain option if you set an option which ends with

water in the drum.

• Make sure that the drain filter is not clogged. Clean the

filter, if necessary. Refer to 'Care and cleaning'.

• Adjust manually the items in the tub and start the spin

phase again. This problem may be caused by balance

problems.

There is water on the

floor.

• Make sure that the couplings of the water hoses are

tight and there is not water leakages.

• Make sure that the water inlet hose and the drain hose

have no damages.

• Make sure you use the correct detergent and the correct

quantity of it.

You cannot open the

appliance lid.

• Make sure that the washing programme is finished.

• Set the drain or the spin option if there is water in the

tub.

The appliance makes

an unusual noise.

• Make sure the levelling of the appliance is correct. Refer

to 'Installation instruction'.

• Make sure that the packaging and/or the transit bolts

are removed. Refer to 'Installation instruction'.

• Add more laundry in the drum. The load may be too

small.

The washing results are

not satisfactory.

• Increase the detergent quantity or use a different deter‐

gent.

• Use special products to remove the stubborn stains be‐

fore you wash the laundry.

• Make sure that you set the correct temperature.

• Decrease the laundry load.

You cannot set an op‐

tion.

• Make sure that you press only the wanted touch but‐

ton(s).

After the check, activate the appliance. The programme continues from the point of

interruption.

If the problem occurs again, contact the Authorised Service Centre.

ENGLISH

19