Electrolux EWT 2852 EWW - Инструкция по эксплуатации - Страница 17

12.6 Cleaning the inlet hose and the valve filter

1.

1

2

3

2.

3.

4.

90˚

12.7 Emergency drain

Because of a malfunction, the appliance

cannot drain the water.
If this occurs, do steps (1) through (5) of

'Cleaning the drain filter'. If necessary,

clean the pump.

12.8 Frost precautions

If the appliance is installed in an area

where the temperature can be less than

0° C, remove the remaining water from

the inlet hose and the drain pump.
1. Disconnect the mains plug from the

mains socket.

2. Close the water tap.

3. Put the two ends of the inlet hose in

a container and let the water flow out

of the hose.

4. Empty the drain pump. Refer to the

emergency drain procedure.

5. When the drain pump is empty,

install the inlet hose again.

WARNING!

Make sure that the

temperature is higher than 0

°C before you use the

appliance again.

The manufacturer is not

responsible for damages

caused by low temperatures.

13. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

13.1 Introduction

The start of the appliance does not occur

or it stops during operation.

ENGLISH

17