Maunfeld MBWM.148W - Инструкция по эксплуатации - Страница 17

17

SM3153

INSTALLING THE WASHING  MACHINE

 CONNECTING THE WATER SUPPLY

The mains water pressure must be between 0.05 and 1.00 Mpa 

(0.5 - 10 bar.)

▼

  Before connecting the washing machine, open the valve and allow a certain 

quantity of water to flow out in order to clean the pipes of any sand or rust. 

This operation is particularly important in the case where the washing machine 

has been left standing for a long time or when connecting to a new water supply 

system. 

▼

  The fill hose must be connected to the mains supply using a ¾” threaded con-

nection.

On electronic washing machines fitted with a dual solenoid valve 

(hot and cold water), connect the red hose to the hot water supply 

valve and the other hose to the cold water supply valve.  

If a hot water supply is not available, both hoses must be connected to the 

cold supply using the fitting supplied (see fig. 8). 
Do not connect to the hot water supply.

▼

  Connect the fill hose (fig. 9).

Washing machines and condensation type washer/driers must 

be connected to the mains water supply using the new hoses 

provided with the appliance. The old hoses must not be re-used.

▼

  During the wash, the water supply valve must be fully open.

▼

  The drain hose must be positioned at a height of between 60 cm and 90 cm 

(fig. 10).

▼

  If the water is drained directly into the drainage system, the free end of the 

drain hose must be inserted in a pipe of internal diameter not les than 40 mm.

▼

  The drain hose connection to the drainage system must not be hermetically 

sealed, as this would cause a build up of air in the siphon and allow water to 

leak out.

▼

  If the wash water is drained into a washbasin, sink or other similar system, the 

free end of the hose must be reinforced at the bend using the bracket supplied 

with the washing machine. Place the hose over the edge of the washbasin and 

anchor the bracket in such as manner that prevents the hose from falling (fig. 

11). The washbasin outlet must be clean and must allow the water to flow freely.

8

10

11

9

7

EN