AL-KO SNOWLINE 620E II - Инструкция по эксплуатации - Страница 31

GB

31

469186_c

Snow Line 560 II, 620 II, 620E II

Maintaining the auger drive

Adjusting the control cable

If the auger drive no longer engages when the engine is 

running, the control cable must be adjusted.

Caution!

▪

Switch off the engine before adjusting the con-

trol cable.

▪ If the auger drive mechanism cannot be disen

-

gaged, switch off the engine. Do not attempt 

repair; contact a qualified workshop.

1.  Loosen the lock nut (  

41-1

).

2. 

Turn the adjustment on the control cable in the 

direction of the arrow (  

41-2

) until the control 

cable does not sag (i.e. is somewhat taut) when 

the clutch lever is pressed. Hold the cable while 

tightening so that it does not twist.

3.  Tighten the lock nut.
4. 

Check the adjustment by starting the engine and 

engaging the auger drive. 

5.  If the auger drive still does not engage and 

disengage properly, have the machine repaired by 

a qualified workshop.

Replacing the shear pins

If the auger is blocked, the shear pins (  

25-1

)

  may 

break in order to ensure safe operation.

▪

Replace broken shear pins with original re-

placement parts. Using unauthorised replace

-

ment parts may cause severe damage to the 

machine! 

▪ See the replacement parts list when ordering 

replacements.

1. 

Switch off the machine and disconnect the spark 

plug connector.

2. 

Remove damaged shear pins 

(  

42-2

).

3. 

Check the shaft for damage.

4.  Insert new shear pins and secure with safety split 

pins (  

42-1

)..

Storage

If the machine is stored for a long period of time, for ex

-

ample, after the winter season, heed the following:

Danger - risk of explosion!

Do not store the machine near an open flame or 

heat source.

„

Empty the carburettor.

„

Start the engine.

„

Close the fuel tap.

„

Wait until the engine dies.

„

Allow the engine to cool.

„

Store in a dry area that is inaccessible to children 

and unauthorised persons.

„

Either empty the petrol tank or fill it completely.

„

Remove the engine key.

„

Disconnect the spark plug connector.

Disposal

Do not dispose of worn-out machines, 

batteries or rechargeable batteries in the 

household rubbish!

Packaging, device and accessories are made 

of recyclable materials and are to be disposed 

of accordingly.

Repairs

Repairs may be performed only by qualified workshops.

Have a qualified workshop perform and inspection:

„

After running onto an obstacle.

„

If the engine stops suddenly.

„

If the auger or impeller is damaged.