Stanley STDH5510 - Инструкция по эксплуатации - Страница 7

Setting the drilling depth (fig.B)       

•  Slacken the side handle (7) by turning the grip counter 

clockwise.

•  Set the depth stop (6) to the desired position. The 

maximum drilling depth is equal to the distance between 

the tip of the drill bit and the front end of the depth stop.

•  Tighten the side handle by turning the grip clockwise.

Switching on and off

•  To switch the tool on, press the variable speed switch(1). 

The tool speed depends on how far you press the 
switch. As a general rule, use low speeds for large 
diameter drill bits and high speeds for smaller diameter 
drill bits.

•  For continuous operation, press the lock-on button (2) 

and release the variable speed switch. This option is 
available only at full speed in both forward and reverse 
modes.

•  To switch the tool off, release the variable speed switch. 

To switch the tool off when in continuous operation, 
press the variable speed switch again and release it.

Maintenance   

Your STANLEY power tool has been designed to operate 
over a long period of time with a minimum of maintenance. 
Continuous satisfactory operation depends upon proper tool 
care and regular cleaning.

Important

To ensure product SAFETY  and RELIABILITY, repairs, 

maintenance and adjustment ( other than those listed in this 
manual) should be performed by authorized service centers 

or other qualified organizations, always –using identical 

replacement parts inside.

Cleaning    

Warning!

 Blow dirt and dust out the main housing 

with dry air as often as dirt is seen collecting in and 

around the air vents. Wear approved eye protection and 
approved dust mask when performing this procedure. 

Warning!

 Never use solvents or other harsh 

chemicals for cleaning the non – metallic parts of 

the tool. These chemicals may weaken the materials used in 
these parts. Use a cloth dampened only with water and mild 
soap. Never let any liquid get inside the tool; never immerse 
any part of the tool into a liquid.

Accessories

The performance of any power tool is dependent 

upon the accessory used. STANLEY accessories 

are engineered to high quality standards and are 

designed to enhance the performance of power tool.

STANLEY offers a large selection of accessories available at 

our local dealer or authorized service center at extra cost.

Caution:  

The use of any other accessory not 

recommended for use with this tool could be hazardous.

Service Information

STANLEY offers a full network of company-owned and 

authorized service locations throughout Europe. All 

STANLEY Service Centers are staffed with trained 

personnel to provide customers with efficient and reliable 

power tool service. Whether you need technical advice, 

repair , or genuine factory replacement parts, contact the 

STANLEY location nearest to you.

Notes  

•  STANLEY’s policy is one of continuous improvement to 

our products and, as such , we reserve the right to 

change product specifications without prior notice. 

•  Standard equipment and accessories may vary by 

country.

•  Product specifications may differ by country.

•  Complete product range may not be available in all 

countries. Contact your local STANLEY dealers for range 

availability.

7

ENGLISH

(Original instructions)