Stanley STDC18LHBK - Инструкция по эксплуатации - Страница 6

6

ENGLISH    

(Original instructions)

•  Injuries caused by prolonged use of a tool. When using 

any tool for prolonged periods ensure you take regular 

breaks.

•  Impairment of hearing.

•  Health hazards caused by breathing dust developed 

when using your tool (example:- working with wood, 

especially oak, beech and MDF.)

Vibration

The declared vibration emission values stated in the 

technical data and the declaration of conformity have been 

measured in accordance with a standard test method 

provided by EN 60745 and may be used for comparing one 

tool with another. The declared vibration emission value may 

also be used in a preliminary assessment of exposure.

Warning! 

The vibration emission value during actual use of 

the power tool can differ from the declared value depending 

on the ways in which the tool is used. The vibration level 

may increase above the level stated.

When assessing vibration exposure to determine safety 

measures required by 2002/44/EC to protect persons 

regularly using power tools in employment, an estimation of 

vibration exposure should consider, the actual conditions of 

use and the way the tool is used, including taking account of 

all parts of the operating cycle such as the times when the 

tool is switched off and when it is running idle in addition to 

the trigger time.

Labels on tool

The following pictograms are shown on the tool:

Warning!

 To reduce the risk of injury, the user must

read the instruction manual.

Position of date barcode

The Date Code, which also includes the year of

manufacture, is printed into the housing.

Example:

2014 XX JN

             Year of manufacturing

Additional safety instructions for

batteries and chargers

Batteries

•  Never attempt to open for any reason.

•  Do not expose the battery to water.

•  Do not store in locations where the temperature may 

exceed 40 °C.

•  Charge only at ambient temperatures between 10 °C and 

40 °C.

•  Charge only using the charger provided with the tool.

•  When disposing of batteries, follow the instructions given 

in the section “Protecting the environment”.

Do not attempt to charge damaged batteries.

Chargers

•  Use your charger only to charge the battery in the tool 

with which it was supplied. Other batteries could burst, 

causing personal injury and damage.

•  Never attempt to charge non-rechargeable batteries.

•  Have defective cords replaced immediately.

•  Do not expose the charger to water.

•  Do not open the charger.

•  Do not probe the charger.

The charger is intended for indoor use only.

Read the instruction manual before use.

The charger automatically shuts off if the ambient 

temperature becomes too high. The thermal cut out 

operates only once and then requires complete replacement.

Electrical safety

Your charger is double insulated; therefore no earth 

wire is required. Always check that the mains 

voltage corresponds to the voltage on the rating 

plate. Never attempt to replace the charger unit with a regular 

mains plug.

•  If the supply cord is damaged, it must be replaced by the 

manufacturer or an authorised STANLEY Service Centre 

in order to avoid a hazard.

Features

This tool includes some or all of the following features.

1.  Variable speed switch

2.   Forward/reverse slider

3.   Mode selector / torque adjustment collar

4.   Chuck

5.   Speed selector

6.   Bit holder

7.   Battery

8.   LED work light

9.   State of charge indicator

10.  Belt clip

FIG. A

11.  Charger

12.  Charge indicator