Шуруповерты Rebir IE 1305 А-16/1300 ЕR 07.001.00010 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
SAFETY INSTRUCTIONS
Unplug the drill before making any adjustments or inspections.
Check cable and plug for damage prior to connecting the drill to a power supply.
Replace defective or damaged cable at authorized service centre.
Do not operate the drill if:
– any part of the drill is damaged;
– the power switch does not work properly;
– the brushes are sparking at the commutator and a circular flame is visible;
– smoke or a distinctive odour of burning insulation is detected.
Never carry the drill by the cable.
Do not expose the cable to heat or oil.
Make sure that arbour, chuck and drill bit are attached properly prior to turning the
drill on.
Use only sharp drill bits.
Never connect the drill to an electrical ground.
Make sure that there are no hidden wires in the location (wall, panel, ceiling or
floor) where you are going to drill.
Switch off immediately if the drill stops (loss of power, jamming of moving
parts,etc.).
Always wear protective eye glasses.
When working with concrete or stone use a face mask.
Keep children at a distance. Do not allow them to come in contact with the cable.
Do not use the drill in the presence of flammable or explosive liquids, gases or
dusts.
Never allow the drill to become wet.
After finishing the job always remove the plug from the power supply socket.
When not in use, the drill should be stored in a locked place out of reach of children.
For further safety information please refer to the additional «Safety
Instructions» enclosed.
INITIAL OPERATION
Always use the correct supply voltage. The voltage specifications as shown on
label must correspond to the supply voltage. (±10% deviation is allowed).
INITIAL OPERATION
Switching on for a short time
Switching on:
press the power switch
7
(Fig. 1).
Switching off:
release the switch
7
.
Switching on for a longer time
Switching on:
press the power switch
7
and fix the position by pressing the lock-on
button
6
.
Switching off:
press and release the power switch
7
.
DRILL SPINDLE ROTATION SPEED SELECTION
For IE-1305A-16/1300ER: set the necessary spindle rotation speed by turning the
adjusting wheel
8
.
For IE-1305-16/1300R: spindle rotation speed is not adjustable.
1305 07.201
1
- 16 -
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)
