Makita TD111DZ - Инструкция по эксплуатации - Страница 5

5 ENGLISH

Overloaded:

The tool is operated in a manner that causes it to draw 

an abnormally high current.

In this situation, turn the tool off and stop the application 

that caused the tool to become overloaded. Then turn 

the tool on to restart.

If the tool does not start, the battery is overheated. In 

this situation, let the battery cool before turning the tool 

on again.

Low battery voltage:

The remaining battery capacity is too low and the tool 

will not operate. If you turn the tool on, the motor runs 

again but stops soon. In this situation, remove and 

recharge the battery.

Indicating the remaining battery 

capacity

Only for battery cartridges with "B" at the end of the 

model number

1

2

►    

1.

 Indicator lamps 

2.

 Check button

Press the check button on the battery cartridge to indi

-

cate the remaining battery capacity. The indicator lamps 

light up for few seconds.

Indicator lamps

Remaining

capacity

Lighted

Off

75% to 100%

50% to 75%

25% to 50%

0% to 25%

NOTE:

 Depending on the conditions of use and the 

ambient temperature, the indication may differ slightly 

from the actual capacity.

Switch action

1

►    

1.

 Switch trigger

CAUTION:

Before installing the battery car-

tridge into the tool, always check to see that the 

switch trigger actuates properly and returns to 

the "OFF" position when released.

To start the tool, simply pull the switch trigger. Tool 

speed is increased by increasing pressure on the switch 

trigger. Release the switch trigger to stop.

NOTE:

 The tool automatically stops if you keep pull

-

ing the switch trigger for about 6 minutes.

Lighting up the front lamp

CAUTION:

Do not look in the light or see the 

source of light directly.

1

►    

1.

 Lamp