Makita DTD157RTJ - Инструкция по эксплуатации - Страница 7

7 ENGLISH

NOTE:

 Depending on the conditions of use and the 

ambient temperature, the indication may differ slightly 

from the actual capacity.

NOTE:

 The first (far left) indicator lamp will blink when 

the battery protection system works.

Tool / battery protection system

The tool is equipped with a tool/battery protection sys

-

tem. This system automatically cuts off power to the 

motor to extend tool and battery life. The tool will auto

-

matically stop during operation if the tool or battery is 

placed under one of the following conditions:

Overheat protection

When the tool/battery is overheated, the tool stops 

automatically and the lamp blinks. In this situation, let 

the tool/battery cool before turning the tool on again.

Overdischarge protection

When the battery capacity is not enough, the tool stops 

automatically. In this case, remove the battery from the 

tool and charge the battery.

Switch action

► 

Fig.3:

1.

 Switch trigger

CAUTION:

Before installing the battery car-

tridge into the tool, always check to see that the 

switch trigger actuates properly and returns to 

the "OFF" position when released.

To start the tool, simply pull the switch trigger. Tool 

speed is increased by increasing pressure on the switch 

trigger. Release the switch trigger to stop.

NOTE:

 The tool automatically stops if you keep pull

-

ing the switch trigger for about 6 minutes.

Electric brake

This tool is equipped with an electric brake. If the tool 

consistently fails to quickly stop after the switch trigger 

is released, have the tool serviced at a Makita service 

center.

Lighting up the front lamp

CAUTION:

Do not look in the light or see the 

source of light directly.

► 

Fig.4:

1.

 Lamp

► 

Fig.5:

1.

 Button

Pull the switch trigger to turn on the lamp. To turn off, 

release it. The lamp goes out approximately 10 seconds 

after releasing the switch trigger.

To keep the lamp off, turn off the lamp status. First pull 

and release the switch trigger. And then press the but-

ton 

 for one second within 10 seconds.

To turn on the lamp status again, press the button again 

similarly.

NOTE:

 To confirm the lamp status, pull the trigger. 

When the lamp lights up by pulling the switch trigger, 

the lamp status is ON. When the lamp does not come 

on, the lamp status is OFF.

NOTE:

 When the tool is overheated, the light flashes 

for one minute, and then the LED display goes off. In 

this case, cool down the tool before operating again.

NOTE:

 Use a dry cloth to wipe the dirt off the lens of 

the lamp. Be careful not to scratch the lens of lamp, or 

it may lower the illumination.

Reversing switch action

► 

Fig.6:

1.

 Reversing switch lever

CAUTION:

Always check the direction of 

rotation before operation.

CAUTION:

Use the reversing switch only after 

the tool comes to a complete stop.

 Changing the 

direction of rotation before the tool stops may dam

-

age the tool.

CAUTION:

When not operating the tool, 

always set the reversing switch lever to the neu-

tral position.

This tool has a reversing switch to change the direction 

of rotation. Depress the reversing switch lever from the 

A side for clockwise rotation or from the B side for coun-

terclockwise rotation.

When the reversing switch lever is in the neutral posi-

tion, the switch trigger cannot be pulled.