Makita DF332DWAE - Инструкция по эксплуатации - Страница 9

9 ENGLISH

Installing driver bit holder

Optional accessory

1

2

►    

1.

 Driver bit holder 

2.

 Driver bit

Fit the driver bit holder into the protrusion at the tool foot 

on either right or left side and secure it with a screw.

When not using the driver bit, keep it in the driver bit 

holders. Driver bits 45 mm-long can be kept there.

OPERATION

CAUTION:

Always insert the battery cartridge 

all the way until it locks in place.

 If you can see 

the red part on the upper side of the button, it is not 

locked completely. Insert it fully until the red part can-

not be seen. If not, it may accidentally fall out of the 

tool, causing injury to you or someone around you.

CAUTION:

When the speed comes down 

extremely, reduce the load or stop the tool to 

avoid the tool damage.

Hold the tool firmly with one hand on the grip and the 

other hand on the bottom of the battery cartridge to 

control the twisting action.

Screwdriving operation

CAUTION:

Adjust the adjusting ring to the 

proper torque level for your work.

CAUTION:

Make sure that the driver bit is 

inserted straight in the screw head, or the screw 

and/or driver bit may be damaged.

Place the point of the driver bit in the screw head and 

apply pressure to the tool. Start the tool slowly and then 

increase the speed gradually. Release the switch trigger 

as soon as the clutch cuts in.

NOTE:

 When driving wood screw, pre-drill a pilot hole 

2/3 the diameter of the screw. It makes driving easier 

and prevents splitting of the workpiece.

Drilling operation

First, turn the adjusting ring so that the pointer points to 

the 

marking. Then proceed as follows.

Drilling in wood

When drilling in wood, the best results are obtained 

with wood drills equipped with a guide screw. The guide 

screw makes drilling easier by pulling the drill bit into 

the workpiece.

Drilling in metal

To prevent the drill bit from slipping when starting a 

hole, make an indentation with a center-punch and 

hammer at the point to be drilled. Place the point of the 

drill bit in the indentation and start drilling.

Use a cutting lubricant when drilling metals. The excep-

tions are iron and brass which should be drilled dry.

CAUTION:

Pressing excessively on the tool 

will not speed up the drilling.

 In fact, this excessive 

pressure will only serve to damage the tip of your drill 

bit, decrease the tool performance and shorten the 

service life of the tool.

CAUTION:

Hold the tool firmly and exert care 

when the drill bit begins to break through the 

workpiece.

 There is a tremendous force exerted on 

the tool/drill bit at the time of hole break through.

CAUTION:

A stuck drill bit can be removed 

simply by setting the reversing switch to reverse 

rotation in order to back out. However, the tool 

may back out abruptly if you do not hold it firmly.

CAUTION:

Always secure small workpieces 

in a vise or similar hold-down device.

CAUTION:

If the tool is operated continuously 

until the battery cartridge has discharged, allow 

the tool to rest for 15 minutes before proceeding 

with a fresh battery.