Fein Dsceu638 72043000235 - Инструкция по эксплуатации - Страница 15

15

en

Handling hazardous dusts

For work procedures with this power tool where mate-
rial is removed, dusts develop that can be hazardous to 
one’s health.
Contact with or inhaling some dust types, e. g. asbestos 
and asbestos-containing materials, lead-containing coat-
ings, metal, some wood types, minerals, silicate particles 
from materials containing stone, paint solvents, wood 
preservatives, antifouling paints for vessels, can trigger 
allergic reactions to the operator or bystanders and/or 
lead to respiratory infections, cancer, birth defects or 
other reproductive harm. The risk from inhaling dusts 
depends on the exposition. Use dust extraction matched 
appropriately for the developing dust, as well as personal 
protective equipment and provide for good ventilation of 
the workplace. Leave the processing of asbestos-contain-
ing materials to specialists.
Wood and light-metal dust, hot mixtures of sanding dust 
and chemical materials can self-ignite under unfavourable 
conditions or cause an explosion. Avoid sparking in the 
direction of the dust collector as well as overheating of 
the power tool and the materials being sanded, empty the 
dust collector/container in time, observe the material 
manufacturer’s working instructions, as well as the rele-
vant regulations in your country for the materials being 
worked.

Operating instructions.

Degrease the output spindle and the inside cone of the 
drill chuck before mounting.
Change the gear setting or the rotation direction only 
after the motor has come to a complete stop.
For stationary use in a drill stand, remove the switched 
off power tool from the drill stand every 50 operating 
hours while at normal running temperature. Then, turn 
the machine around by 180 °  to achieve uniform lubrica-
tion.

Repair and customer service.

When working metal under extreme operat-
ing conditions, it is possible for conductive 
dust to settle in the interior of the power tool. 

The total insulation of the power tool can be impaired. 
Blow out the interior of the power tool via the ventila-
tion slots frequently with dry and oil-free compressed air, 
and connect a residual current device (RCD) on the line 
side.
If the supply cord of this power tool is damaged, it must 
be replaced by a specially prepared cord available through 
the FEIN customer service centre.

If required, you can change the following parts yourself:

drill chuck, auxiliary handle, depth stop, application tools

Warranty and liability.

The warranty for the product is valid in accordance with 
the legal regulations in the country where it is marketed. 
In addition, FEIN also provides a guarantee in accordance 
with the FEIN manufacturer’s warranty declaration.
The delivery scope of your power tool may include only 
a part of the accessories described or shown in this 
instruction manual.

Declaration of conformity.

FEIN declares itself solely responsible for this product 
conforming with the relevant provisions given on the last 
page of this Instruction Manual.

Environmental protection, disposal.

Packaging, worn out power tools and accessories should 
be sorted for environmental-friendly recycling.

OBJ_BUCH-0000000016-001.book  Page 15  Wednesday, October 13, 2010  1:40 PM