DEKO GCD20DU3 SET 5 063-4145 - Инструкция по эксплуатации - Страница 4

4

may exhibit unpredictable behaviour resulting in fire, explosion or risk of injury. 

f) 

Do not expose a battery pack or tool to fire or excessive temperature 

. 

Exposure to fire or tem-

perature above 40 °C may cause explosion. 

g) 

Follow all charging instructions and do not charge the battery pack or tool outside the tempera-

ture range specified in the instructions. 

Charging improperly or at temperatures outside the speci-

fied range may damage the battery and increase the risk of fire. 

6) Service

a) 

Have your power tool serviced by a qualified repair person using only identical replacement 

parts

. 

This will ensure that the safety of the power tool is maintained. 

b) 

Never service damaged battery packs.

Service of battery packs should only be performed by the 

manufacturer or authorized service providers. 

1) 

Wear ear protectors and goggles when impact drilling.

 Exposure to noise can cause hearing 

loss. 

2) 

Dusts from materials such as lead-containing coatings, some wood types, minerals and metal 

can be harmful to one’s health and cause allergic reactions, lead to respiratory infections and/or 
cancer. 

Materials containing asbestos may only be worked by specialists.

– please always keep the working place clean and  well-ventilated.  
– it is recommended to wear a p2 filter-class respirator.
Observe the relevant regulations in your country for the materials to be worked.

3) 

Before any work on the machine (e.G., Maintenance, tool change, etc.) as well as during trans-

port and storage, set the rotational direction switch (forward/reverse switch ) to the center posi-
tion. 

Unintentional actuation of the on/off trigger can lead to injuries.

4) 

Hold power tool by insulated gripping surfaces, when performing an operation where the 

cutting accessory or fastener may contact hidden wiring. 

Cutting accessory and fasteners contact-

ing a “live” wire may make exposed metal parts of the power tool “live” and could give the operator 
an electric shock.

5) 

Hold the machine with a firm grip. 

High reaction torque can briefly occur while driving in and loos-

ening screws. Secure the workpiece. A workpiece clamped with clamping devices is held more 
secure than by hand.

6) 

Never operate at higher speed than the maximum speed rating of the drill bit. 

At higher speeds, 

the bit is likely to bend if allowed to rotate freely without contacting the workpiece, resulting in 
personal injury. 

7) 

Always start drilling at low speed and with the bit tip in contact with the workpiece.

At higher 

speeds, the bit is likely to bend if allowed to rotate freely without contacting the workpiece, resulting 
in personal injury. 

8) 

Apply pressure only in direct line with the bit and do not apply excessive pressure.

Bits can 

bend causing breakage or loss of control, resulting in personal injury. 

Additional Safety Warnings for Drills and Screw Drivers