Worx WX801.9 - Инструкция по эксплуатации - Страница 8

8

EN

6. SERVICE

a)  Have your power tool serviced by a qualified repair person using only 

identical replacement parts. 

This will ensure that the safety of the power 

tool is maintained.

SAFETY INSTRUCTIONS FOR ALL OPERATIONS

Safety Warnings Common for Grinding or Abrasive Cutting-Off Operations:

a)   This power tool is intended to function as a grinder or cut-off tool. 

Read all safety warnings, instructions, illustrations and specifications 

provided with this power tool. 

Failure to follow all instructions listed below may 

result in electric shock, fire and/or serious injury.

b)   Operations such as sanding, wire brushing, polishing are not 

recommended to be performed with this power tool. 

Operations for which 

the power tool was not designed may create a hazard and cause personal injury.

c)   Do not use accessories which are not specifically designed and 

recommended by the tool manufacturer. 

Just because the accessory can be 

attached to your power tool, it does not assure safe operation.

d)   The rated speed of the accessory must be at least equal to the 

maximum speed marked on the power tool. 

Accessories running faster than 

their rated speed can break and fly apart.

e)   The outside diameter and the thickness of your accessory must be 

within the capacity rating of your power tool. 

Incorrectly sized accessories 

cannot be adequately guarded or controlled.

f)   Threaded mounting of accessories must match the grinder spindle 

thread. For accessories mounted by flanges, the arbour hole of the 

accessory must fit the locating diameter of the flange. 

Accessories that 

do not match the mounting hardware of the power tool will run out of balance, vibrate 

excessively and may cause loss of control.

g)   Do not use a damaged accessory. Before each use inspect the 

accessory such as abrasive wheels for chips and cracks, backing 

pad for cracks, tear or excess wear. If power tool or accessory is 

dropped, inspect for damage or install an undamaged accessory. 

After inspecting and installing an accessory, position yourself and 

bystanders away from the plane of the rotating accessory and run 

the power tool at maximum no-load speed for one minute.

Damaged 

accessories will normally break apart during this test time.

h)   Wear personal protective equipment. Depending on application, use 

face shield, safety goggles or safety glasses. As appropriate, wear 

dust mask, hearing protectors, gloves and workshop apron capable 

of stopping small abrasive or workpiece fragments. 

The eye protection 

must be capable of stopping flying debris generated by various operations . The dust 

mask or respirator must be capable of filtrating particles generated by your operation. 

Prolonged exposure to high intensity noise may cause hearing loss.

i)   Keep bystanders a safe distance away from work area. Anyone 

entering the work area must wear personal protective equipment. 

Fragments of workpiece or of a broken accessory may fly away and cause injury 

beyond immediate area of operation.

j)   Hold the power tool by insulated gripping surfaces only, when 

performing an operation where the cutting tool may contact hidden 

wiring. 

Contact with a “live” wire will also make exposed metal parts of the power tool